Potensic RID-916 - Remote ID Module Manual

Installation method

Introduction

1. LED Indicators
   LED1~LED4 are battery indicators, and LED1 is also a status indicator.

   Device Status	LED1 Color
   Satellite search	Flashing green slowly
   Broadcast mode (satellite search completed)	Solid green
   Refresh takeoff point	Flashing cyan slowly
   Extreme low battery	Flashing red slowly
   Device malfunction	Solid red

2. GPS Antenna
   When using RID-916, make sure this side is facing up without covering.
   
3. Power Button
   Long press: power on/off the device.
4. Type-C Charging Port

Instructions

Charing

Pull out the dustproof rubber plug and connect to a USB charger (5V/0.5A or above) or power bank via the Type-C cable to charge. (This product does not include a USB charger. Please use chargers that comply with FCC/CE standards to charge.)
When charging with the device off, LED1 will be solid yellow and LED2-LED4 will flash white sequentially. After being fully charged, all the LEDs will turn off.
When charging with the device on, LED1 will display the color of the device status, while LED2-LED4 will flash white sequentially. After being fully charged, all the LEDs will stay solid on.

Power on/off

1. Long press the power button for 2s until all the LEDs are on/off and release to power on/off the device.
2. When the device is powered on, LED1 will display the current status of the device while LED2-LED4 will indicate the battery level as follows:

When LED1 flashes red slowly, it indicates that the device has extreme low battery level and needs to be charged as soon as possible.
When LED1 is solid red, it indicates that the device is malfunctioning. Please contact the after-sales service for support.

How to Use

1. Install RID-916 that has been successfully written with the required information on the drone.
   Installation Precautions:
   • Place the module level with the logo side facing the sky.
   • When installing, do not block the drone's GPS antenna and keep a safe distance from the propellers.
   • If the drone is a small quadcopter, try to install the module at the center of gravity of the drone (the focus of the cross-connection of the four motors).
2. Long press the power button for 2s until all the LEDs are on and release to power on RID-916.
3. After being powered on, the device will automatically start satellite search with LED1 flashing green slowly.
   When LED1 stays green, it indicates that RID-916 has finished satellite search and starts to broadcast.
4. Short press the power button and RID-916 will refresh the takeoff point with LED1 flashing cyan slowly. When LED1 stays green, it indicates that the takeoff point has been refreshed successfully and it's ready to fly.
   It's required to use RID-916 outdoors with the logo side facing the sky. RID-916 broadcasts: drone ID, drone location and altitude, drone velocity, time mark, takeoff location and elevation.

Specifications

Model: RID-916
Weight: Color: grey
Dimension: length: 37.6mm, width: 31.6mm, thickness: 15.9mm
Working temperature: 0~40℃
Maximum horizontal receiving distance: >300m
Battery life: Up to 4 hours
GPS positioning accuracy: 3m
(open and interference-free environment)
Bluetooth: supports Bluetooth 5.1 and above
Bluetooth transmission power: 8dbm
Battery: 310mAh lithium battery, 1S
Rated capacity: 310mAh 1.15Wh
Rated voltage: 3.7V
Rated charging current: 5V 140mA
Maximum charging current when powered on: 5V 200mA
Charging port: Type-C
Installation methods: supports various methods

The product should only be used by adults and children over 16 years. Adult supervision is required for children under 16 years.

www.potensic.com
support@potensic.com