Numark WS100 - Microphone Transmitter Manual

Introduction

Box Contents

• WS100 Microphone Transmitter
• WS100 Receiver
• Carrying Case
• 1/4" (6.35 mm) cable
• Power Adapter
• User Guide
• Safety & Warranty Manual

Support

For the latest information about this product (system requirements, compatibility information, etc.) and product registration, visit numark.com.
For additional product support, visit numark.com/support.

Setup

Connection

Here is just an example of how to use your WS100 in your setup. Items not listed in Introduction > Box Contents are sold separately.

Setting Up the Microphone Transmitter

1. Remove the microphone transmitter's battery compartment cover and insert 2 AA batteries into compartment. Make sure the polarities of the batteries (+ and –) are correct.
2. Reattach the battery compartment cover.
3. Slide the power switch into the on position. The power indicator will flash briefly to indicate the microphone transmitter is on.

Setting Up the Receiver

1. For best results, place the receiver at least 3 feet (1 meter) above the ground and place theantennae in a vertical position.
2. Use the included power adapter to connect the receiver's power input to a power outlet.
3. Use a standard 1/4" (6.35 mm) cable to connect one of the receiver's audio outputs to your mixer or PA system. Do not use both audio outputs at the same time; this can result in signal loss or increased noise.
4. Press the power button to turn the receiver on.
5. If the microphone transmitter is on, the receiver's RF indicator will light to show that the two devices are connected and within range. The receiver and microphone transmitter are pre-programmed to operate on a regional fixed frequency.
6. Adjust the volume knob to set the audio signal level sent from the audio output to your mixer or PA system.

Features

Microphone Transmitter

1. Grille: This cover protects the microphone capsule and reduces noise from air and breath.
2. Power Switch: This three-position switch turns the transmitter on or off.
   1. The transmitter is off.
   2. The transmitter is on, but the audio signal is muted.
   3. The transmitter is on and sending audio to the receiver.
3. Power Indicator: This LED will flash briefly when the power switch is moved into the on position.
4. Battery Compartment: Insert 2 AA batteries into the compartment. Make sure the polarities of the batteries (+ and –) are correct.

Receiver

Front Panel

1. Power Button: Press this button to turn the receiver on or off.
2. Power Indicator: When lit, this LED indicates the receiver is powered on.
3. RF Indicator: When lit, this LED indicates that the receiver is receiving a signal from the transmitter.
4. AF Indicator: When lit, this LED indicates the current audio signal level received from the transmitter.
5. Volume Knob: Turn this knob to adjust the volume level of the Mic Output and Line Output.
6. Antennae: These antennae receive the signal from the transmitter. Place the antennae in a vertical position for the best signal quality.

Rear Panel

1. Power Input: Use the included power adapter to connect this input to a power outlet.
2. Mic Output (1/4" / 6.35 mm): Use a standard 1/4" (6.35 mm) cable to connect this balanced output to your mixer, PA system, etc. Make sure the input of the connected device is set to receive a mic-level audio signal.
3. Line Output (1/4" / 6.35 mm): Use a standard 1/4" (6.35 mm) cable to connect this unbalanced output to your guitar amplifier, mixer, PA system, etc. Make sure the input of the connected device is set to receive a line-level audio signal.

Troubleshooting