Sharper Image 210331 User Manual

Thank you for purchasing the LED Hand Pain Relief Mitten. Please read this
manual thoroughly before operating this device.
CHARGING THE DEVICE
Your device may come with a charge. If so, fully deplete the battery before
the next charge. Otherwise, before your first treatment, fully charge for 2-4
hours. The power indicator light on the control panel will turn green while
charging and will go out when the battery is fully charged.
Usage Instructions
1. Prep:
• Wash and dry your hand(s) to start with clean skin, free of any
light-blocking ingredients.
2. Power:
• Insert the USB plug from the pad into the provided USB power
supply.
• Plug the USB power supply into an electrical outlet.
• Press the On/Off button to start the device. Slide your hand into
the opening in the device. (Note: All settings are pre-configured at
the factory).
3. Relax:
• Leave your hand in the device for the full 30-minute treatment.
The device will auto shut-off.
• You can also manually turn off the device by pressing the On/Off
button to stop the device. (Note: all settings are pre-configured at
the factory).
4. Repeat:
• If desired, move the device to the other hand and repeat the steps
above.
• The device may be used multiple times per day.
NOTE: You can only see the red LEDs; the other LEDs are in the infrared
light spectrum and can't be seen with the human eye.
LIGHT SENSITIVITY TEST
Test yourself for light sensitivity before starting your treatment
1. Power on the device.
2. Place the device on or within ¼'' of the skin on your forearm for 3
minutes.
3. After 3 minutes, check the area. If the area has turned red and remains
so for more than 2 hours, your skin is light sensitive.
4. If sensitivity occurs, discontinue use and contact Customer Service.
LED HAND PAIN RELIEF MITTEN
Item No. 210331
User Guide
- 1 -