Raymarine MaxiView ST60 Owner's Handbook Manual
  1. Manuals
  2. Brands
  3. Raymarine Manuals
  4. Repeater
  5. MaxiView ST60
  6. Owner's handbook manual
Raymarine MaxiView ST60 Owner's Handbook Manual

Raymarine MaxiView ST60 Owner's Handbook Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
ST60 MaxiView
Owner's
Handbook
Document number: 81156-2
Date: 1st April 2001

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MaxiView ST60 and is the answer not in the manual?

Questions and answers

Summary of Contents for Raymarine MaxiView ST60

  • Page 1 ST60 MaxiView Owner’s Handbook Document number: 81156-2 Date: 1st April 2001...
  • Page 3 Autohelm and SeaTalk are registered trademarks of Raymarine Ltd. The information in this handbook was correct at the time it went to press. Raymarine operates a policy of continuing improvement and updating and therefore reserves the right to change the product specification without notice.

  • Page 5: Table Of Contents

    Introduction Contents Introduction ................v Package contents ..............vii Chapter 1: Installation ............1 1.1 Siting ................1 1.2 Mounting procedure (cockpit/bulkhead) ....2 1.3 Bracket Mounting ............2 1.4 Flush Mounting ............3 1.5 Power supply ............... 3 Chapter 2: Remote Installation ..........5 2.1 SeaTalk Socket Installation .........
  • Page 6 ST60 MaxiView Instrument Owner’s Handbook Cruising mode ............11 Race mode ..............12 4.2 Full Mode ..............13 Depth ................. 13 Speed Key ..............14 HDG Key ..............15 Wind Key ..............16 NAV Key ..............17 Timer Control ............18 4.3 Cruising Mode .............

  • Page 7: Introduction

    Introduction Introduction Congratulations. You are now the owner of an ST60 MaxiView intelligent SeaTalk repeater. This instrument will provide you with access to the full range of SeaTalk performance and navigational information via a single instrument lead. Whatever your type of boat, power or sail, MaxiView gives you a large scale display of unprecedented clarity, as a result of the advanced super-twist LCD display technology used.
  • Page 8 ST60 MaxiView Instrument Owner’s Handbook If the boat's system contains a radio navigation receiver (with SeaTalk output or an NMEA 0183 interface), the following information is also available: • Speed Over Ground • Course Over Ground • Bearing to Waypoint •...

  • Page 9: Package Contents

    Introduction Package contents The ST60 MaxiView contains the following items: • Item 1 ST60 MaxiView instrument. • Item 2 Fixing studs (2). • Item 3 Thumb nuts (2). • Item 4 Fitting template. • Item 5 Instrument cover. • Item 6 Owner’s Handbook. A Warranty document is included at the rear of the handbook.
  • Page 10 ST60 MaxiView Instrument Owner’s Handbook...

  • Page 11: Chapter 1: Installation

    Chapter 1: Installation Chapter 1: Installation 38.75 mm (1.5 in) 177.8 mm (7 in) 24 mm (0.95 in) 110 mm (4.33 in) D1050-3 1.1 Siting The ST60 MaxiView can be mast, helm or cockpit/bulkhead mounted. When mast or helm mounting the MaxiView requires a custom Autohelm mast or stormrail mounting pod: 2 unit Mastpod –...

  • Page 12: Mounting Procedure (Cockpit/Bulkhead)

    - these expand and may, if applied to the seal attached to the rear case, distort the MaxiView casing. 1.3 Bracket Mounting As an alternative to bulkhead mounting, the ST60 MaxiView can, be bracket mounted using the Raymarine mounting kit (Catalogue No. D130).

  • Page 13: Flush Mounting

    Chapter 1: Installation D1327-2 1.4 Flush Mounting A flush mounting kit is available for situations where a low-profile installation is required or more desirable. Full instructions are provided with the kit (Catalogue No. E25017). D1326-3 1.5 Power supply Power for the ST60 MaxiView is taken from the SeaTalk bus.
  • Page 14 ST60 MaxiView Instrument Owner’s Handbook Keel D671-3 The SeaTalk cable from the MaxiView pod should be connected to the cable tail of the last instrument in the existing SeaTalk system.

  • Page 15: Chapter 2: Remote Installation

    Chapter 2: Remote Installation Chapter 2: Remote Installation 2.1 SeaTalk Socket Installation The MaxiView remote controller (A25006) is SeaTalk compatible and controls the MaxiView instruments via the SeaTalk bus. It is supplied with a custom waterproof plug and socket. The plug comes ready assembled to the remote cable and the socket can be mounted in the cockpit area or anywhere a remote control is required.

  • Page 16: Mounting/Cabling

    ST60 MaxiView Instrument Owner’s Handbook 2.2 Mounting/Cabling The socket is assembled as follows: 1. Apply the self adhesive template to the bulkhead at the selected location. 2. Carefully drill an 18 mm (23/32 in) clearance hole and two 2.4 mm (3/32 in) pilot holes. Remove the template. 3.

  • Page 17: Bulkhead Bracket Installation

    Chapter 2: Remote Installation Screen Identification Yellow Stripes D1097-2 2.3 Bulkhead bracket installation The ST60 MaxiView remote is supplied with a bulkhead mounted stowage bracket. This should be attached to a convenient bulkhead using the 3 double sided adhesive pads supplied with the unit. D1098-3...
  • Page 18 ST60 MaxiView Instrument Owner’s Handbook...

  • Page 19: Chapter 3: Fault Finding And Maintenance

    Chapter 3: Fault Finding and Maintenance 3.1 Fault Finding All Raymarine products are subject to comprehensive test and quality assurance programmes, prior to packing and shipping. However, if a fault arises with the ST60 MaxiView, the following table may help to identify the probable cause and provide the most likely cure.
  • Page 20 ST60 MaxiView Instrument Owner’s Handbook...

  • Page 21: Chapter 4: Operation

    Chapter 4: Operation Chapter 4: Operation 4.1 Introduction The ST60 MaxiView can be programmed to operate in Full mode, Cruising mode or Race mode. Full mode Full mode Full mode Full mode Full mode In Full mode most functions are displayed in large format and called up by cycling the relevant key.

  • Page 22: Race Mode

    ST60 MaxiView Owner’s Handbook Race mode Race mode Race mode Race mode Race mode Race mode allows the user to define up to 6 screens from either the Full or Cruising menus, which can be remotely paged using the Maxi Remote Controller (A25006).

  • Page 23: Depth

    Chapter 4: Operation DEPTH DEPTH DEPTH FATHOMS (only if feet is selected) DEPTH TEMPERATURE DEPTH TIMER DEPTH D1053-3 Note: Fathoms will only be displayed if the units are set to FEET on the main depth instrument. If the depth echo is lost LOST ECHO will be displayed alternately with FEET or METRES .

  • Page 24: Speed Key

    ST60 MaxiView Owner’s Handbook Speed Key SPEED BOAT SPEED SPEED SPEED TRIP AVERAGE SPEED MAX SPEED SPEED D1054-3 resets the MAXIMUM speed reading. A one second press of SPEED Speed will automatically be displayed in either mph or knots depending on the setup of the main speed instrument.

  • Page 25: Hdg Key

    Chapter 4: Operation HDG Key HDG. LOCKED COMPASS HEADING HDG. CURRENT COMPASS HEADING HDG. COURSE OVER THE GROUND HDG. BEARING TO WAYPOINT HDG. D1055-3 Note: Headings will be either True or Magnetic depending on the calibration setting (refer to section 5.1). The units displayed by the master instrument will be those displayed by the repeating unit.

  • Page 26: Wind Key

    ST60 MaxiView Owner’s Handbook Wind Key WIND APPARENT WIND SPEED WIND APPARENT WIND ANGLE WIND TRUE WIND SPEED WIND TRUE WIND ANGLE WIND TRUE WIND ANGLE (Relative to boat) WIND OPPOSITE TACK COMPASS HEADING WIND D1056-3 Wind will automatically be displayed in either knots or mph depending on the setup of the main wind instrument.

  • Page 27: Nav Key

    Chapter 4: Operation NAV Key LATITUDE LONGITUDE CROSS TRACK ERROR COURSE OVER GROUND SPEED OVER GROUND TIDE-SET TIDE-DRIFT WAYPOINT NUMBER BEARING TO WAYPOINT DISTANCE TO WAYPOINT CROSS TRACK ERROR VMG THROUGH WATER VMG TO WAYPOINT VMG OVER GROUND TIME DATE TIDE-SET TIDE-DRIFT D1057-3...

  • Page 28: Timer Control

    ST60 MaxiView Owner’s Handbook Timer Control DEPTH 1 second TIMER 1 second DEPTH DEPTH 10 MINUTE TIMER RUNNING COUNTDOWN SELECT DEPTH DEPTH 1 second 5 MINUTE TIMER FROZEN COUNTDOWN SELECT DEPTH DEPTH 1 second TIMER RUNNING DEPTH 1 second D1058-3 When the timer is running, a 1 second press of will stop the timer.

  • Page 29: Cruising Mode

    Chapter 4: Operation 4.3 Cruising Mode WIND HDG. SPEED DEPTH CURRENT DEPTH APP WIND ANGLE CURRENT HDG CURRENT SPEED LATITUDE CURRENT SPEED APP WIND SPEED LOCKED HDG AVERAGE SPEED LONGITUDE APP WIND SPEED TRUE WIND ANGLE SPEED OVER GROUND CROSS TRACK ERROR APP WIND ANGLE TRUE WIND SPEED BRG TO WPT...
  • Page 30 ST60 MaxiView Owner’s Handbook DEPTH BOAT SPEED DEPTH TRIP AVERAGE SPEED MAXIMUM SPEED DEPTH COURSE OVER GROUND SPEED OVER GROUND TIDE-SET TIDE-DRIFT DEPTH VMG THROUGH WATER VMG TO WAYPOINT VMG OVER GROUND DEPTH SEA TEMPERATURE DEPTH TIMER DEPTH D1085-3...

  • Page 31: Remote Control

    Chapter 4: Operation 4.5 Remote Control The MaxiView can be remotely controlled using the Maxi Remote Control (cat. no. A25006). Each instrument can be programmed to respond directly to each key or page through a sequence of pre- programmed displays. D1063-3 Operation In FULL or CRUISING mode the remote control will operate the...
  • Page 32 ST60 MaxiView Owner’s Handbook...

  • Page 33: Chapter 5: Calibration Procedures

    Chapter 5: Calibration Chapter 5: Calibration Procedures The MaxiView has a Calibration mode that allows various operating parameters to be set up. These include: • Operating mode • Measurement units • Local Magnetic Variation • True or Magnetic bearing display •...
  • Page 34 ST60 MaxiView Owner’s Handbook WIND 2 seconds CALIBRATION TEMPERATURE UNITS TRUE OR MAGNETIC SELECTION SEATALK TRUE/MAG SELECTION LOCAL MAGNETIC VARIATION DATE FORMAT OPERATING MODE REMOTE KEY SELECTION Screen (Race mode only) D1060-2...
  • Page 35 Chapter 5: Calibration In RACE mode five possible settings are available: • NONE: MaxiView ignores remote key. 1: MaxiView responds to the remote • DEPTH key only. 2: MaxiView responds to the remote • key only. 3: MaxiView responds to the remote •...

  • Page 36: Intermediate Calibration

    ST60 MaxiView Owner’s Handbook 8. Move the pointer back to SCREEN and select the next screen number by holding down for 1 second. DEPTH 9. To continue basic calibration, press 10. To store the selected screens press for 2 seconds. WIND 11.

  • Page 37: Extended Calibration

    Chapter 5: Calibration 5.3 Extended Calibration Extended calibration contains a calibration on/off feature, damping menus and a boat show program. Calibration On/Off This feature is designed to protect your customised basic calibration settings. Once it is switched on, access is restrained to the extended calibration menu only.
  • Page 38 ST60 MaxiView Owner’s Handbook 14 seconds WIND SOFTWARE VERSION momentarily DEPTH SPEED CALIBRATION ON/OFF DEPTH DAMPING SPEED DAMPING WIND SPEED DAMPING WIND ANGLE DAMPING HEADING DAMPING COG DAMPING SOG DAMPING BOAT SHOW D1300-2...

  • Page 39: Limited Warranty Certificate

    During this period, except for certain products, travel costs (auto mileage and tolls) up to 100 round trip highway miles (160 kilometres) and travel time of 2 hours, will be assumed by Raymarine only on products where proof of installation or commission by authorized service agents, can be shown.
  • Page 40 Factory Service Centers United States of America UK, Europe, Middle East, Far East Raymarine Inc Raymarine Ltd 22 Cotton Road, Unit D Anchorage Park, Portsmouth Nashua, NH 03063-4219, USA PO3 5TD, England Telephone: +1 603 881 5200 Telephone: +44 (0)23 9269 3611...

Table of Contents