Panasonic Viera TH-50PF10 Operating Instructions Manual page 10

Connections
TH-65PF10UK
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
Speaker terminal (R)
Note:
Make sure that the AC cord is locked
on both the left and right sides.
– Cable fi xing bands
Pass the attached cable
fi xing band through the clip
as shown in the fi gure.
1
SLOT1
Optional Terminal
Board Insert Slot
(covered)
Note:
At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
10
AC cord connection (see page 14)
– AC cord fi xing
Plug the AC cord
1
into the display
unit.
Plug the AC cord
until it clicks.
2 Fix the AC cord
with the clamper
which is attached
to the unit.
Secure any excess cables with bands as required.
To secure cables connected to Terminals, wrap the cable fi xing band around them then
pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
SLOT2
Dual HDMI Terminals COMPONENT/RGB IN and
(equivalent of Dual Audio IN Terminals (equivalent
HDMI Terminal Board of BNC Component Video
(TY-FB10HMD)) Terminal Board (TY-42TM6A))
(see page 13) (see page 13)
Speaker
terminal (L)
Close
Push until
t h e h o o k
clicks.
Open
2. Pull off.
1. Keep the
knob pressed.
To loosen:
To tighten:
Push the catch
Pull
R AUDIO L P /C /R P /C /B Y/G
R R B B
COMPONENT/RGB IN
SLOT3
From EXTERNAL
monitor terminal
on Computer
(see page 11)
1
2
2
Unplug the AC cord
Unplug the AC cord pressing the
two knobs.
Note:
When disconnecting the AC cord, be
absolutely sure to disconnect the AC
cord plug at the socket outlet fi rst.
Pull
AUDIO
PC IN SERIAL
From SERIAL
Terminal on
Computer
(see page 12)
1