1. Manuals
  2. Brands
  3. ADENDORFF Manuals
  4. Sander
  5. MAC AFRIC SSANDR-001
  6. Operation instructions manual

ADENDORFF MAC AFRIC SSANDR-001 Operation Instructions Manual

Random orbit sander
Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

SSANDR-001
Read through carefully and understand these instructions before use.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MAC AFRIC SSANDR-001 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for ADENDORFF MAC AFRIC SSANDR-001

Summary of Contents for ADENDORFF MAC AFRIC SSANDR-001

  • Page 1 SSANDR-001 Read through carefully and understand these instructions before use.

  • Page 2: General Power Tool Safety Warnings

    GENERAL POWER TOOL SAFETY WARNINGS Personal Safety (For All Power Tools) 9. Stay alert, watch what you are doing and use common sense when operating a power tool. Do WARNING! Read and understand all instructions. Failure to follow all instructions listed below may result in not use a power tool while you are tired or under the influence of drugs, alcohol, or medication.

  • Page 3: Additional Safety Rules

    parts and any other condition that may affect the power tool’s operation. If damaged, have ADDITIONAL SAFETY RULES the power tool repaired before use. Many accidents are caused by poorly maintained power tools. Instructions for All Operations 22. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting General Safety Warning for Sanding edges are less likely to bind and are easier to control.

  • Page 4: Instructions For Operation

    Never get close to rotating parts. decreased, therefore, do not stick it to the pad for further use. Do not stand on the place where the tool may move to when bouncing. To install the abrasive paper, first remove all dirt or foreign matter from the pad. Then carefully align the holes in Be very careful when working on the sharp corners or edges.

  • Page 5: Maintenance And Inspection

    MAINTENANCE AND INSPECTION CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 1. Inspecting the Mounting Screws Regularly inspect all mounting screws and ensure that they are properly tightened. Should any of the screws be loose, retighten them immediately.
  • Page 6 EXPLANATION OF GENERAL VIEW Pan Head Tapping Screw PCBA Speed adjusting Assembly Rear Cover Terminal Block Capacitor Strain Relief Switch Cord Guard Rubber Pad Cord Pan Head Tapping Screw Left Baseplate Spring Dust Bag Carbon Brush Dust collection rack Carbon Brush Holder Holder Plate Right Baseplate Nameplate...

Table of Contents