Formax FlashGuard 13R6 Operator's Manual

6. Troubleshooting Guide
Problem Cause
Machine has no Power cord is not properly
power or rollers are plugged in
not moving.
Main power switch is off
Excessive noise Operation of gears is not
smooth.
Poor lamination Laminated document
quality wrinkled, damp, or folded
Temperature will not Power cord is not properly
increase plugged in
Power switch off
Edges are not sealed Document is too thick to
seal the edges of the film
Unable to feed Something may be stuck
between the heated rollers
or they are out of position
7. Technical Support
If you have any problems that cannot be solved on-site, please contact your
Formax reseller, or contact the Formax Service Team directly at 800-232-5535.
Solution
Check the power plug is
properly plugged in
Check the power switch is
turned on or contact support
Turn off the machine,
then contact support
A
djust the temperature
lower or higher
(see Temperature/Speed Chart)
Check the power plug is
properly plugged in
Check the power switch is
turned on or contact support
Use a thinner document or
leave more space around the
edges, approximately .19" (5mm)
Follow the shut-down procedure,
and contact support.
FlashGuard 13R6 / 18R6
Heavy Duty Professional Laminators
Rev. 10/23
Operator Manual