Summary of Contents for ChefMaster HEG580
- Page 1 Chefmaster LED Insect Control Unit Instruction Manual Model HEG580 - LED Insect control unit (100m² coverage) HEG581 - LED Insect control unit (150m² coverage)
-
Page 2: Operation
Thank you for purchasing your Chefmaster LED Insect Control Unit. To make full use of the product please read this manual carefully before using the product and keep it safe for future reference. Safety Tips • If you find any damage when the product is unpacked, contact your Chefmaster distributor within 24 hours of receipt of goods •... -
Page 3: Troubleshooting
Unit is not working The unit is not switched on Check unit is plugged in and switched on The plug or lead are damaged Contact your Chefmaster distributor. Contact your approved service agent. No high voltage The UV-A LED light stop working Replace the UV-A LED. - Page 4 Bulb replacement is to be carried out by a suitably qualified professional. Disconnect unit from mains power. Check condition of unit before performing any work. Use Personal Protective Equipment. HEG580 - 100m² coverage Remove the collection tray. Place the unit front face down on a suitable level work surface.
- Page 5 HEG580 Remove the LED diffuser cover. Locate the LED bulb connector on the PCB. Carefully lift the PCB from the slots on the body. Remove the LED bulb connector from the PCB Remove the old LED bulb from the body.
- Page 6 HEG580 Note the location of the blue & red wires and the orientation of the heat sink on the bulb Free the wires from the heat sink and remove. Extra care must be taken not to damage/deform the heat sink during this step.
- Page 7 HEG580 Place the grid on to the screw raisers. Replace the four screws. Check everything is seated correctly. Replace the top cover carefully. Ensure that no cables are snagged and that the power switch aligns and seated correctly. Replace the thirteen screws...
- Page 8 HEG581 – 150m² coverage Remove the collection tray. Place the unit front face down on a suitable level work surface. Remove seven screws. Place the cover to one side. Remove the four screws securing the upper grid in place Note. One screw has a wiring terminal attached. Remove upper grid and place to one side.
- Page 9 HEG581 Remove the lower grid and place to one side. Using a plastic tool, gently push the tabs to release the diffuser from the body of the unit Carefully turn the unit over Disconnect the LED strip connector from the wiring terminal.
- Page 10 HEG581 Turn the unit over. Place the bottom grid on to the body upstands and ensure the holes are aligned. Place the wiring terminal onto the grid and align. Replace four screws, ensure terminal is secure. Place the top grid on to the body upstands and ensure the holes are aligned.
- Page 11 Weight: 1.44kgs Dimensions: 318mm x 318mm x 64mm • Chefmaster LED insect control are supplied with a 3 pin plug and lead with a 13 amp fuse • Appliance must be earthed • If in doubt contact a qualified electrician or your Chefmaster distributor Disposal Under WEEE regulations this product must not be disposed of as household waste.
Need help?
Do you have a question about the HEG580 and is the answer not in the manual?
Questions and answers