Subscribe to Our Youtube Channel
Summary of Contents for mac.pan ELE-FE1
- Page 1 Instrumentation Production cycle Digital control panel ELE-FE1 DIGITAL INSTRUMENTATION...
- Page 3 Pag. Instrumentation Initial settings Switch the controller on and off Set the time Set the day Set the ceiling and bedplate temperature Set and change the baking time Production cycle Startup Start the baking timer End of the baking cycle Stop the baking timer before the end Automatic restart Set the automatic restart time...
- Page 4 Instrumentation CEILING DISPLAY BEDPLATE DISPLAY digital control panel PAG. 4 CAP. 4 ELE FE1...
- Page 5 SET TEMPERATURE to set the ceiling or bedplate set point BAKING TIMER to set the baking time START baking time start and stop CLOCK to set the current time and the automatic oven restart timer DAILY REPEAT to set the current day and enable the automatic restart days PROGRAMS to set and enable the baking programs STEAM EXTRACTOR...
-
Page 6: Initial Settings
Initial settings Switch the controller on and off Hold the ON/OFF key for several seconds if the instrument is on, it will turn off; if it is off, it will turn on. Once on, the controller starts bringing the oven to temperature, according to the set temperatures Set the time Hold the CLOCK key for 3 seconds... - Page 7 Production cycle Startup Activate the supply of the oven (power e water) Set the required temperature on the temperature control. Set the cooking time on the relative timers and the required drying time. Wait approx. 30 minutes to allow the oven and the humidifier to reach the desired temperature.
-
Page 8: Automatic Restart
Automatic restart Set the automatic restart time You can set the oven to restart automatically at a certain time but only if the controller is on. Press and release the CLOCK key The TIME display shows the restart time; the minutes are blinking. Use the UP and DOWN arrows on the right to change the minutes. - Page 9 Baking programs The instrument can memorise up to 9 baking programs and for each of them, it can memorise: - the (set) temperature of the bedplate - the (set) temperature of the ceiling - the baking time You cannot select or modify any program during the baking cycle. Setting a program with the oven RUNNING Press and release the PROGRAMS key;...
- Page 10 Steam Steam generator When you press the STEAM GENERATOR key , the Steam Generator turns on or off. When the steam generator is on, the LED of the key is Steam injection The steam injection function is enabled only if the LED of the Steam Generator is on. Once the steam output is enabled, it remains on for a certain time that can be set from the keyboard.
- Page 11 Energy Saver Function The ENERGY SAVER function can be enabled by pressing the relevant key. If both areas, the ceiling and the bedplate, require power at the same time, this function prevents the overloading of the power supply line and alternates the activation of the two areas.
-
Page 12: Useful Information
4.10 Useful Information Cooking time in particular can vary according to the type of dough, its homogeneity and volume. Make sure you carefully monitor the first baking cycles and check the results achieved: using the same types of dough under the same conditions, you will obtain standard results. The heat needed to process your dough depends on its preparation, ingredients and liquids. - Page 14 www.macpan.com...
Need help?
Do you have a question about the ELE-FE1 and is the answer not in the manual?
Questions and answers