Empura Equipment E-PC11 Service, Installation And Care Manual

Gas pasta cooker

Advertisement

Quick Links

Gas Pasta Cooker Model
E-PC11
Please read this manual completely before attempting to install or
operate this equipment. Notify carrier of damage! Inspect all
components immediately.
©2024 Empura Equipment
Gas Pasta Cooker
Service, Installation &
Care Manual
www.Empura.com
E-PC11
1
v1-1-24

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the E-PC11 and is the answer not in the manual?

Questions and answers

Summary of Contents for Empura Equipment E-PC11

  • Page 1 Gas Pasta Cooker Service, Installation & Care Manual E-PC11 Gas Pasta Cooker Model E-PC11 Please read this manual completely before attempting to install or operate this equipment. Notify carrier of damage! Inspect all components immediately. www.Empura.com ©2024 Empura Equipment v1-1-24...
  • Page 2: Specifications

    Before attempting to operate your unit, read the instructions in this manual thoroughly. Total Rate (BTU/H) 70,000 70,000*2 www.Empura.com ©2024 Empura Equipment v1-1-24 Throughout this manual, you will find notations enclosed in double-bordered boxes similar to the ones LP.IN. W.C...
  • Page 3: Safety And Warnings

    One of the most important considerations of efficient cooker operation is ventilation. Make sure the cooker is installed to efficiently remove combustion by-products, and the kitchen ventilation system does not produce drafts that interfere with proper burner operation. www.Empura.com ©2024 Empura Equipment v1-1-24...
  • Page 4: Installation & Instructions

    The knob on the gas valve is placed in the PILOT or ON position by rotating it counter-clockwise. To return clockwise. www.Empura.com ©2024 Empura Equipment the knob to the OFF position, the knob must be depressed slightly to disengage its stop tab, then rotated v1-1-24 5.
  • Page 5: Filling With Water

    If gas supply is interrupted, repeat steps 2 through 6. Filling With Water: Turn on facet to fill the water tank with water. Do not exceed the max water-level. Thermostat Operation: Note: The boiling point of water might vary for different altitudes. www.Empura.com ©2024 Empura Equipment v1-1-24...
  • Page 6: Operation

    Inspect the burner deflectors to verify that each is positioned directly above its orifice, and that the flame ignites approximately 2½ inches (60mm) above the orifice. The flame should strike the center of the deflector and be a rich blue color. www.Empura.com ©2024 Empura Equipment v1-1-24 Clean Cooker Cabinet Inside and Out...
  • Page 7: Operator Troubleshooting

    In some cases the operator may not be able to correct the problem, but will at least be able to accurately diagnose the problem, and that will assist a qualified service technician in restoring the equipment to full operation in the shortest possible time www.Empura.com ©2024 Empura Equipment v1-1-24...
  • Page 8: Troubleshooting Chart

    If all of the above causes have been Call service. ruled out. the probable causes are low pilot flame. Pilot generator low millivolt output. High resistance in hi-limit thermostat contacts, or a defective pilot magnet in the gas valve www.Empura.com ©2024 Empura Equipment v1-1-24...

Table of Contents