Mirror remote
expansion kit setup
1.
Locate the box that is labeled "SW11630K".
3.
Power on your Mirror device. The additional remotes can be
paired one at a time and will only need to be paired once.
Remove the primary remote docked in the back, and replace
it with one of your new remotes.
5.
When turned on, the remote's LED will remain solid (if any
remote's LED is still blinking after its pairing process, please
repeat the process outlined in step 3 until you achieve a
solid LED). Four paired remotes should appear as so:
Need help?
Contact us at support@swivl.com or 1-888-837-6209. For more detailed information go to
2.
You will find (1) USB-C to 3 USB-C cable, (1) remote pouch,
and (3) additional Mirror remotes. Please note that the USB-C
cable provided is only intended to charge the extra remotes.
SW11630K
4.
Wait until the remote LED blinks orange followed by two quick
grey pulses. Remove the remote and repeat step three for the
remaining remotes. When all the remotes are paired, turn on
all four remotes by holding the power button for 2 seconds.
6.
To affix the remote pouch to the Mirror device, attach the
velcro straps as shown here:
Grey
Blue
Yellow
Teal
Orange
swivl.com/setup
Need help?
Do you have a question about the SW11630K and is the answer not in the manual?
Questions and answers