Avery Dennison Microstitch Operation & Safety Instructions

NEEDLE
GUARD
Figure 1
LONG END
Figure 2
NEEDLE
LOCK
Figure 3
HOLD
FIRM
SQUEEZE
TO APPLY
Figure 4
NEEDLE
LOCK
NEEDLE
GUARD
SLOT
Figure 5
Avery Dennison Microstitch®
Operation & Safety Instructions
Operating & Safety Instructions
WARNING: Before using tool, read important needle safety procedures. Save these
instructions where tool is stored. IMPORTANT NOTE: Always test the fastening system on
a small sample of each material to be attached prior to use.
REMOVING THE NEEDLE GUARD
1. Remove protective needle guard before using.
2. ALWAYS cover needle with guard when tool is not in use.
LOADING MICRO FASTENERS
1. Insert the long end of the round connecting bar on the micro fastener clip into the round
guide slot at the top of the tool.
2. Gently push the micro fastener clip into the guide until it "clicks" in place. Be careful not
to distort the individual fasteners. The tool is ready for use.
To remove a partially used clip (Figure 3):
1. Squeeze the trigger all the way.
2. Pull the clip out of the round guide slot.
3. Release the trigger all the way.
4. Check partial clip for damage before re-loading.*
*Always discard clips that have micro fasteners that are out of place, distorted or
damaged. A damaged clip can cause feeding or jamming problems.
INSERTING MICRO FASTENERS
1. Push the needle of the tool through the items to be attached.
2. Hold the material firmly against the front of the tool and squeeze the trigger completely.
3. Release the trigger.
4. Withdraw the needle and tool from the material.
5. Material is now securely attached.
6. Always use the needle guard when the tool is not in use.
INSTALLING AND REMOVING NEEDLES
To install the needle:
1. Place the needle, point end first, into the needle guard.
2. Turn the needle lock towards the front of the tool as shown.
3. Insert the needle with the needle slot aligned with the slot in the tool.
4. Once in place, turn the needle lock 180° back towards the rear of the tool.
To remove the needle:
1. Place the needle, point end first, into the needle guard.
2. Turn the needle lock towards the front of the tool as shown.
3. Slide the needle out of the tool.
HELPFUL TIPS:
• Make sure needle is pushed all the way through fabric.
• Keep layers smooth and flat while fastening.
• When basting a quilt, use a basting grate or quilting hoop for fabric support to eliminate
the need to put your hand under the quilt.
• To remove the micro fasteners, use blunt-pointed scissors, cuticle clippers, or a quick
pull with your fingers.
(Figure 1)
(Figure 2)
(Figure 4)
(Figure 5)