Aiwa AV-S17 Operating Instructions Manual
Aiwa AV-S17 Operating Instructions Manual

Aiwa AV-S17 Operating Instructions Manual

Aiwa stereo receiver user's manual av-s17
Hide thumbs Also See for AV-S17:
Table of Contents

Advertisement

Available languages

Available languages

STEREO RECEIVER
RECEPTOR ESTEREO
AMPLI-TUNER STEREO
AV-S17
8A-AR5-903-01
000620CCK-Y-M
For assistance and information
call toll free 1-800-BUY-AIWA
U
OPERATING INSTRUCTIONS
MANUAL DE INSTRUCCIONES
MODE D'EMPLOI
(United States and Puerto Rico)
En
(English)
E
(Español)
F
(Français)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AV-S17 and is the answer not in the manual?

Questions and answers

Summary of Contents for Aiwa AV-S17

  • Page 1 STEREO RECEIVER RECEPTOR ESTEREO AMPLI-TUNER STEREO AV-S17 For assistance and information 8A-AR5-903-01 000620CCK-Y-M OPERATING INSTRUCTIONS MANUAL DE INSTRUCCIONES call toll free 1-800-BUY-AIWA (United States and Puerto Rico) MODE D’EMPLOI (English) (Español) (Français)
  • Page 2 Modifications or adjustments to this product, which are not expressly approved by the manufacturer, may void the user’s right or authority to operate this product. For assistance and information Printed in Malaysia call toll free 1-800-BUY-AIWA (United States and Puerto Rico)
  • Page 3: Precautions

    For your convenience, record the model number and serial number (you will find them on the rear of your unit) in the space provided below. Please refer to them when you contact your Aiwa dealer in case of difficulty. Model No.
  • Page 4: Table Of Contents

    Outdoor Antenna 1 Power lines — When connecting an outdoor antenna, make sure it is located away from power lines. 2 Outdoor antenna grounding — Be sure the antenna system is properly grounded to provide protection against unexpected voltage surges or static electricity build-up. Article 810 of the National Electrical Code, ANSI/NFPA70, provides information on proper grounding of the mast, supporting structure, and the lead-in wire to the antenna discharge unit, as well as the...
  • Page 5: Connecting Equipment

    PREPARATIONS CONNECTIONS Before connecting the AC cord The rated voltage of your unit shown on the rear panel is 120 V AC. Check that the rated voltage matches your local voltage. IMPORTANT Connect the speakers, antennas, and all other external equipment first.
  • Page 6: Connecting Speakers

    1 and 2 in the illustration correspond to the following details. AM antenna Sub woofer CONNECTING SPEAKERS1 Speaker terminals Connect front speakers (system A and/or B) and sub woofer to the corresponding speaker terminals on the unit: - the front speaker cords to the SPEAKERS terminals - for more powerful bass, the sub woofer (with a built-in amplifier) cord to the SUB WOOFER 3 jack Speaker impedance...
  • Page 7: Connecting The Supplied Antennas

    CONNECTING THE SUPPLIED ANTENNAS 2 Connect the FM antenna to the FM 75 antenna to the AM LOOP terminals. FM antenna To stand the AM loop antenna on a surface Fix the claw to the slot as shown in the illustration. To position the antennas FM feeder antenna: Extend this antenna horizontally in a T shape and fix its ends to...
  • Page 8: Setting The Clock

    Operating AIWA CD or DVD players with the remote control You can control the basic functions of AIWA CD or DVD players with the remote control. In principle, the buttons described below have the same function as those on the DVD or CD players.
  • Page 9: Power Economizing Mode

    BEFORE OPERATION To turn the unit on Press the POWER button. Operation is possible after four seconds. The VOL (volume) level or function name is displayed one after the other for the first four seconds. The selected function indicator lights up in red. To change the brightness level of the display 1 Press the ECO button repeatedly until “DIM MODE”...
  • Page 10: Sound

    SOUND CUSTOM AUDIO ADJUSTMENT VOLUME CONTROL Turn the VOLUME control on the unit, or press the VOL buttons on the remote control. The volume level is shown on the display for four seconds. It can be adjusted between 0 and MAX (50). It flashes when set over the level of 44.
  • Page 11: Electronic Graphic Equalizer

    ELECTRONIC GRAPHIC EQUALIZER This unit provides the following five different equalization modes. ROCK: Powerful sound emphasizing treble and bass POP: More presence in the vocals and midrange JAZZ: Accented lower frequencies for jazz-type music CLASSIC: Enriched sound with heavy bass and fine treble BGM: Calm tone with suppressed bass and treble Press the GEQ (Graphic Equalizer) button, and turn the MULTI JOG until the desired equalization mode is...
  • Page 12: Recording An Audio Source

    About the video source to the monitor or TV Selected Video source V1: VIDEO 1, V2: VIDEO 2, V3: VIDEO 3 The selected video source is indicated on the display and the video signal through the MONITOR VIDEO OUT jack is output on the TV.
  • Page 13: Radio Reception

    RADIO RECEPTION MANUAL TUNING 1 Turn the FUNCTION to select the TUNER function, and press the BAND button repeatedly to select the desired band. The display changes to frequency indications after indicating band and video source (V1, V2 or V3) for two seconds. 2 Press the N or M button to select a station.
  • Page 14: Presetting Stations

    PRESETTING STATIONS The unit can store a total of 32 preset stations. When a station is stored, a preset number is assigned to the station. Use the preset number to tune in to a preset station directly. 1 Turn the FUNCTION to select the TUNER function, and press the BAND button repeatedly to select the desired band.
  • Page 15: General

    GENERAL SPECIFICATIONS FM tuner section Tuning range 87.5 MHz to 108 MHz Usable sensitivity 13.2 dBf (IHF) Antenna terminals 75 ohms (unbalanced) AM tuner section Tuning range 530 kHz to 1710 kHz (10 kHz step), 531 kHz to 1602 kHz (9 kHz step) Usable sensitivity 350 µV/m Antenna...
  • Page 16: Care And Maintenance

    CARE AND MAINTENANCE Occasional care and maintenance of the unit is needed to optimize the performance of your unit. To clean the cabinet Use a soft dry cloth. If the surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents, such as alcohol, benzine or thinner as these could damage the finish of the unit.
  • Page 17: Precautions

    Pour plus de commodité, noter le numéro de modèle et le numéro de série (cas numéros se trouvent au dos de l'appareil) dans les cases ci-dessous. Prière de mentionner ces numéros quand on contacte un distributeur Aiwa en cas de difficulté. N° de modèle N° de série (N° de lot) AV-S17 FRANÇAIS...
  • Page 18: Nec Section

    5 Quand l’ampli-tuner n’est pas utilisé — Débranchez l’ampli- tuner de la prise murale si vous prévoyez de ne pas l’utiliser pendant plusieurs mois. Quand le cordon est branché, une petite quantité d’électricité s’écoule vers même s’il est hors tension. Antenne extérieure 1 Lignes électriques —...
  • Page 19: Preparatifs

    PREPARATIFS RACCORDEMENTS Avant de raccorder le cordon secteur La tension nominale de l’ampli-tuner indiquée sur le panneau arrière est de 120 V. Vérifiez si elle correspond à la tension locale. IMPORTANT Raccordez les enceintes, les antennes et les autres appareils en premier.
  • Page 20: Raccordement Des Enceintes

    1 et 2 sur l’illustration correspondent aux détails suivants. AM antenna 2AM antenne Sub woofer 1Caisson de grave RACCORDEMENT DES ENCEINTES 1 Bornes d’enceinte Raccordez les enceintes avant (systèmes A et/ou B) et un caisson de grave aux prises correspondantes de l’ampli-tuner: - les cordons d’enceintes avant aux bornes SPEAKERS - le cordon du caisson de grave (amplifié) à...
  • Page 21 RACCORDEMENT DES ANTENNES FOURNIES 2 Raccordez l’antenne FM aux bornes FM 75 aux bornes AM LOOP. Antenne FM Pour poser l’antenne cadre AM sur une surface Insérez la saillie dans la rainure comme indiqué sur l’ilustration. Pour positionner les antennes Antenne fil FM: Etendez-la à...
  • Page 22: Reglage De L'horloge

    Utilisation des lecteurs CD ou DVD AIWA à l’aide de la télécommande Vous pouvez contrôler les fonctions de base des lecteurs CD ou DVD AIWA à l’aide de la télécommande. En principe, les touches décrites ci-dessous ont la même fonction que celles des lecteurs DVD ou CD.
  • Page 23: Avant De Commencer

    AVANT DE COMMENCER Indicateurs de fonction Pour mettre l’ampli-tuner sous tension Appuyez sur la touche POWER. Le fonctionnement est possible après quatre secondes. Le niveau de VOL (volume) et le nom de la fonction s’affichent l’un après l’autre pendant les quatre premières secondes. L’indicateur de fonction sélectionné...
  • Page 24: Son

    REGLAGE PERSONNEL DU SON REGLAGE DE VOLUME Tournez la commande de VOLUME sur l’ampli-tuner ou appuyez sur les touches VOL de la télécommande. Le niveau sonore est indiqué sur l’afficheur pendant quatre secondes. Il peut être réglé de 0 à 50 (MAX) mais il clignote s’il est réglé...
  • Page 25: Egaliseur Graphique Electronique

    EGALISEUR GRAPHIQUE ELECTRONIQUE L’ampli-tuner présente les cinq modes d’égalisation suivants. ROCK: Son puissant avec accentuation des aigus et des graves POP: Présence améliorée des voix et des médiums JAZZ: Accentuation des basses fréquences pour la musique de type jazz CLASSIC: Son plus riche avec des graves lourds et des aigus fins BGM: Son calme avec graves et aigus supprimés Appuyez sur la touche GEQ (égaliseur graphique) et...
  • Page 26: Enregistrement D'une Source Audio

    A propos de la source vidéo fournie au moniteur ou téléviseur Source vidéo sélectionné V1: VIDEO 1, V2: VIDEO 2, V3: VIDEO 3 La source vidéo sélectionnée est indiquée sur l’afficheur et le signal vidéo transmis par la prise MONITOR VIDEO OUT apparaît sur le téléviseur.
  • Page 27: Reception Radio

    RECEPTION RADIO ACCORD MANUEL 1 Tournez FUNCTION pour sélectionner la fonction TUNER et appuyez plusieurs fois de suite sur BAND pour sélectionner la bande voulue. La fréquence est indiquée après le nom de la gamme et de la source vidéo (V1, V2 ou V3) pendant deux secondes. 2 Appuyez sur N ou M pour sélectionner une station.
  • Page 28: Prereglage Des Stations

    PREREGLAGE DES STATIONS L’ampli-tuner peut mémoriser en tout 32 stations. Quand une station est mémorisée, un numéro de préréglage est affecté à cette station. Utilisez le numéro de préréglage pour accorder directement la station préréglée. 1 Tournez FUNCTION pour sélectionner la fonction TUNER et appuyez plusieurs fois de suite sur la touche BAND pour sélectionner la bande désirée.
  • Page 29: Section Amplificateur

    GENERALITES SPECIFICATIONS Section Tuner FM Plage d’accord 87,5 MHz à 108 MHz Sensibilité utilisable 13,2 dBf (IHF) Bornes d’antenne 75 ohms (asymétrique) Section Tuner AM Plage d’accord 530 kHz à 1710 kHz (intervalle de 10 kHz), 531 kHz à 1602 kHz (intervalle de 9 kHz) Sensibilité...
  • Page 30: Soin Et Entretien

    SOIN ET ENTRETIEN Un entretien occasionnel de l’ampli-tuner est indispensable pour garantir des performances optimales. Pour nettoyer le coffret Utilisez un chiffon doux et sec. Si la surface est extrêmement sale, utilisez un chiffon légèrement imprégné d’une solution détergente neutre. Ne pas utiliser de solvants puissants, tels que l’alcool, la benzine et du diluant, car ils pourraient abîmer la finition.

Table of Contents

Save PDF