1. Manuals
  2. Brands
  3. aebi schmidt Manuals
  4. Spreader
  5. Meyer Hotshot 70
  6. Owner's manual

aebi schmidt Meyer Hotshot 70 Owner's Manual

Commercial broadcast spreader
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

HOTSHOT
COMMERCIAL BROADCAST SPREADER
38170
OWNER'S MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Meyer Hotshot 70 and is the answer not in the manual?

Questions and answers

Related Manuals for aebi schmidt Meyer Hotshot 70

Summary of Contents for aebi schmidt Meyer Hotshot 70

  • Page 1 HOTSHOT COMMERCIAL BROADCAST SPREADER 38170 OWNER’S MANUAL...
  • Page 2 ASSEMBLY INSTRUCTIONS 1) Remove components from carton and place spreader upside down on a padded surface. Fore easier assembly, remove the deflector shield by loosening the two wing bolts. Install LH & RH braces to frame as shown using (4) ¼-20 x 2 ¼” hex bolts and nuts, but do not tighten.
  • Page 3 4) Feed control knob/wire through the T-handle until spring touches the round hole. CAUTION: Do Not Compress Spring at This Time. Feed wire through the square handle tube, be sure wire passes above the bolts in the handle brace. Secure T-handle to the tube with ¼-20 x 2 ¼”...

  • Page 4: Operation

    OPERATION NOTE: This spreader is equipped with a factory installed deflector shield that is used for applying ice melt to narrow areas. Shield is easily removed when ice melt is applied to large areas or when using turf care products. 1) Check the package for the rate setting, and recommended swath width.

  • Page 5: Spread Width

    SPREAD WIDTH Two major factors should be considered when determining correct spreader settings of any product: 1) The product application rate, or the amount of material applied per 1,000 sq ft. 2) The effective pattern width, or the actual width in which material is applied. Label settings are a guide and can be affected by numerous factors.
  • Page 6 RATE SETTING CONVERSION The following provides approximate Meyer Hotshot settings for the units listed FERTILIZER PARTICLE SIZE BAG RATE APPROX. APPROX. POUNDS OF SETTING SPREAD FERTLIZER USED WIDTH PER 1,000 SQ FT COVERAGE 12ft LARGE, HEAVY 12ft 12ft PARTICLES 10ft MEDIUM-MIXED 10ft PARTICLES...

  • Page 7: Warranty

    The conversion should be used as a guideline for establishing proper rate settings for the particular product being applied. These settings are approximate and may vary due to physical characteristics of the product. Walking speed, wear, condition of the turf, and humidity may cause actual rate settings to deviate. No expressed nor implied warranty or guarantee is provided as to coverage or uniformity indicated by these rate settings.
  • Page 8 PARTS LIST FOR MODEL #38170 PART OF OUR SERVICE IS PROVIDING REPLACEMENT PARTS. Parts may be obtained through your local distributor. Be sure to give the following: 1) SPREADER MODEL NUMBER 2) SPREADER NAME 3) PART NUMBER 4) NAME OF PARTS AS SHOWN. IF YOUR LOCAL DISTRIBUTOR CANNOT SUPPLY PARTS, CONTACT: Meyer Products, Inc.

This manual is also suitable for:

38170

Table of Contents