Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for FAURE FGI6453K
Summary of Contents for FAURE FGI6453K
- Page 1 User Manual GETTING STARTED? EASY. EN User Manual FGI6453K...
-
Page 2: Safety Information
VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.faure.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. - Page 3 This appliance may be used in, offices, hotel guest rooms, bed • & breakfast guest rooms, farm guest houses and other similar accommodation where such use does not exceed (average) domestic usage levels. WARNING: The appliance and its accessible parts become hot •...
-
Page 4: Safety Instructions
If the supply cord is damaged, it must be replaced by the • manufacturer, an authorized Service or similarly qualified persons in order to avoid a hazard. Where the appliance is directly connected to the power supply, • an all-pole isolating switch with a contact gap is required. Complete disconnection in compliance with the conditions specified in overvoltage category III must be guaranteed. -
Page 5: Gas Connection
• Before carrying out any operation make sure • Make sure that there is air circulation around the that the appliance is disconnected from the appliance. power supply. • The information about the gas supply is on the • Make sure that the parameters on the rating rating plate. -
Page 6: Before The Installation
• Discoloration of the enamel or stainless steel WARNING! Risk of fire and explosion has no effect on the performance of the appliance. • Fats and oil when heated can release flammable CARE AND CLEANING vapours. Keep flames or heated objects away WARNING! Do not remove the from fats and oils when you cook with them. -
Page 7: Built-In Hobs
Model ........• Butane/Propane: use a flexible tube, PNC ......... equipped with it's collars if it is worth visiting Serial number ......over all it's length and if the appliance runs only on butane. If the appliance runs on Propane, BUILT-IN HOBS use a flexible pipe with suitable metal end. -
Page 8: Adjustment Of Minimum Level
• from town gas G130 8 mbar to natural gas applicable pressure adjuster on the gas supply G20/G25 20/25 mbar, tighten the bypass pipe. screw approximately 3/4 of a turn. • from liquid gas to town gas G130 8 mbar, ADJUSTMENT OF MINIMUM LEVEL undo the bypass screw approximately 1 To adjust the minimum level of the burners:... - Page 9 • Do not let the power cable to heat up to a ASSEMBLY temperature higher than 90°C. ON-TOP INSTALLATION CONNECTION CABLE To replace the connection cable use only the special cable or its equivalent. The cable type is: H05V2V2-F T90. min.
- Page 10 min. min. 2 mm 12 mm min. 2 mm < 20 mm min. 500 mm 30 mm 12 mm 57 mm 28 mm 41 mm 38 mm 31 mm min. 38 mm min. 2 mm min. 2 mm > 20 mm min.
-
Page 11: Integrated Installation
INTEGRATED INSTALLATION min. 12 mm min. 2 mm min. 38 mm min. 2 mm POSSIBILITIES FOR INSERTION Kitchen unit with door The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. -
Page 12: Product Description
Kitchen unit with oven The electrical connection of the hob and the oven must be installed separately for safety reasons and min 20 mm to let easy remove oven from the unit. (max 150 mm) 60 mm CAUTION! The bottom of the appliance can get hot. -
Page 13: Control Panel Layout
CONTROL PANEL LAYOUT Use the sensor fields to operate the appliance. The displays, indicators and sounds tell which functions operate. Sensor field Function Comment ON / OFF To activate and deactivate the hob. Lock / Child Safety Device To lock / unlock the control panel. Pause To activate and deactivate the function. -
Page 14: Residual Heat Indicator
Display Description PowerBoost operates. There is a malfunction. + digit A cooking zone is still hot (residual heat). Lock / Child Safety Device operates. Incorrect or too small cookware or no cookware on the cooking zone. Automatic Switch Off operates. RESIDUAL HEAT INDICATOR The indicator may also appear: •... -
Page 15: Induction Cooking Zones
Ignition of the burner The flame that surrounds the Always light the burner before you put thermocouple is a pilot flame. It on the cookware. prevents unexpected shutdown. WARNING! Be very careful when you use open fire in the kitchen environment. - Page 16 To activate the function or change the time: Heat setting The hob deactivates after touch of the timer to set the time (00 - 99 minutes). When the indicator of the cooking zone starts to flash, the time counts down. 6 hours , 1 - 2 To see the remaining time: touch...
-
Page 17: Hints And Tips
• P15 — 1500 W To activate the function: touch comes on • P20 — 2000 W for 4 seconds. • P25 — 2500 W • P30 — 3000 W To deactivate the function: touch . The previous heat setting comes on. CAUTION! Make sure that the selected power fits to the house When you deactivate the hob, you also... -
Page 18: Examples Of Cooking Applications
Cookware is suitable for an induction hob if: CAUTION! Liquids spilt during • water boils very quickly on a zone set to the cooking can cause the glass to break. highest heat setting. • a magnet pulls on to the bottom of the DIAMETERS OF COOKWARE cookware. -
Page 19: Care And Cleaning
Heat setting Use to: Time (min) Hints 1 - 2 Solidify: fluffy omelettes, baked 10 - 40 Cook with a lid on. eggs. 2 - 3 Simmer rice and milkbased 25 - Add the minimum twice as much dishes, heating up ready-cooked liquid as rice, mix milk dishes meals. -
Page 20: Periodic Maintenance
3. After you clean the pan supports, make sure • Remove shiny metallic discoloration: use a that they are in correct positions. solution of water with vinegar and clean the 4. For the burner to operate correctly, make sure glass surface with a cloth. that the arms of the pan supports are inserted •... - Page 21 WHAT TO DO IF... Problem Possible cause Remedy You cannot activate or operate The hob is not connected to an Check if the hob is correctly the hob. electrical supply or it is con- connected to the electrical nected incorrectly. supply.
- Page 22 Problem Possible cause Remedy The cookware is incorrect. Use the correct cookware. Refer to “Hints and tips” chap- ter. The diameter of the bottom of Use cookware with correct di- the cookware is too small for mensions. the zone. Refer to “Technical data” chap- ter.
-
Page 23: Technical Data
LABELS SUPPLIED WITH THE ACCESSORIES BAG Stick the adhesive labels as indicated below: MOD. MOD. MOD. TYPE PROD.NO. IP20 PROD.NO. PROD.NO. SER.NO. 0049 SER.NO SER.NO 03 IT DATA DATA MADE IN ITALY A. Stick it on Guarantee Card and send this part C. -
Page 24: Bypass Diameters
BYPASS DIAMETERS BURNER Ø BYPASS 1/100 mm Ultra Rapid Semi-rapid OTHER TECHNICAL DATA Gas original: G20/G25 (2E+) 20/25 mbar 4,5 kW Gas replace- G30 (3+) 28-30 mbar 334 g/h TOTAL POW- ment: G31 (3+) 37 mbar 329 g/h G130 (1c) 8 mbar 4,15 kW Electric 3680 W... -
Page 25: Energy Efficiency
0,45 175° Installation kit to be ordered from Authorised Service Centre. ENERGY EFFICIENCY PRODUCT INFORMATION ACCORDING TO EU 66/2014 Model identification FGI6453K Type of hob Built-in hob Number of electric cooking zones Heating technology per electric cooking Induction zone Diameter of circular electric cooking Left rear 14.0 cm... -
Page 26: Environmental Concerns
ENVIRONMENTAL CONCERNS Return the product to your local recycling facility or Recycle materials with the symbol . Put the contact your municipal office. packaging in relevant containers to recycle it. Help protect the environment and human health by Electrolux Appliances AB - Contact Address: Al. recycling waste of electrical and electronic Powstancow Slaskich 26, 30-570 Krakow, Poland appliances.
Need help?
Do you have a question about the FGI6453K and is the answer not in the manual?
Questions and answers