1.1 About the manual Warning! Exhaust P6010 PCC is used in applications where a constant vacuum pressure is desired. The manual is available for download at piab.com in the 12 languages shown on page 2. The original instructions are written in English.
In the event that, contrary to indications, dusts, oil mists, fumes, etc. are suctioned, these will be mixed with the discharge air of Manual P6010 PCC Page 4/16...
• To avoid personal injury, equipment damage and application failure, ensure that the compressed air line is properly secured. Manual P6010 PCC Page 5/16...
Each unit is identified by a label with tank-volumes. identification information. For any • communication with Piab AB or service Do not use compressed air pressure centers always refer to the label information. or electrical voltage outside the specification.
3.2 Product overview 3.3 Internal connections P6010 PCC is used in applications where a The PCC is built in a “closed loop”, which constant vacuum pressure is desired. When means that the microprocessor compares the P6010 PCC starts up, it works with...
5.95 7.73 9.36 Cannot be specified The P6010 PCC should always be connected to a stabilized 24 V power supply and an external control voltage (setpoint). The unit is controlled either by an external control unit (a PLC, for example) or by a simple potentiometer.
B. Regulator exhaust port, PCC 4.2 Electric connection Figure 4 Detail A zoomed. Pin no Description +24VDC Power supply 0-10V Setpoint value GND Supply / Signal Analog out 0-10V Not used Cables >3m might need filters and/or shield clamps. Manual P6010 PCC Page 9/16...
Page 10
4V Power supply > 120 mA P6010 PCC Pin 1 +24 VDC Power supply 0-10V Setpoint value Pin 2 0-10V Setpoint value Signal ground Pin 3 GND Supply / Signal Pin 4 Analog out 0-10V Pin 5 Not used 24V Power supply >...
Seller or its authorized representatives, or have a defect as a result of fair wear and tear or willful damage or caused by subsequent damages caused by other defective products. Manual P6010 PCC Page 14/16...
Environmental aspects are considered in the development process of Piab’s products to make sure that a minimal environmental footprint is used. Piab is certified against with ISO-14001, and also complies with REACH (EC 1907/2006). The ways of handling recycling and...
Need help?
Do you have a question about the P6010 PCC and is the answer not in the manual?
Questions and answers