This combination of symbol and signal words indica- the improvement of our products. tes an imminently dangerous situation which may lead to death or severe injuries if they are not avoided. IHG 1500 | Version 2.02...
If the safety markings are not immediately recognizable with the machine which are indicated in the individual pa- and comprehensible, the induction heater should be ta- ragraphs of these instructions. ken out of service until new safety markings have been affixed. IHG 1500 | Version 2.02...
4.2 Typen plate Intended use The induction heating system IHG 1500 serves exclusi- vely for use in the automotive and engineering indu- stries. It is suitable for removing parts such as glass panes, cladding, strips and stickers from metallic sur- faces, as well as for loosening stuck and rusted parts and for repairing small dents in metallic surfaces, e.g.
IHG 1500 into the case. Use available non-volatile detergents for grease, oil and dirt. Prior to the first reuse of the IHG 1500, all compo- nents should be allowed to air dry. No part of the device may be submerged in water or other liquids.
The device may only be connected to a power supply Side coil L=220mm M12 (26) 641 1126 with a grounded neutral conductor! Side coil L=220mm M16 (32) 641 1132 Side coil L=220mm M20 (38) 641 1138 Side coil L=220mm M22 (45) 641 1145 IHG 1500 | Version 2.02...
Keep the po- wer cord away from heat, oil, sharp edges, or moving Do not try to repair the IHG 1500. The unit contains no parts. Never repair the power cord - if it is damaged, the user-serviceable components, except replaceable heating power cord must be replaced.
ATTENTION! The coil and the heated object reach a very high tem- perature and can cause burns or fire if handled improperly. IHG 1500 | Version 2.02...
Electromagnetic compatibility in residential buildings and buildings in which the devices are connected directly to a low-voltage power supply typical for residential buildings is not ensured. IHG 1500 | Version 2.02...
3. Press the power button and guide the coil with a rotary motion over the material. 4. After heating the material, leave the coil Cool for at least 2 minutes. Fig. 7: Attachable front coils IHG 1500 | Version 2.02...
- Check if the fan is working properly. the high voltage terminals of the primary transformer se- parate from the low voltage terminals of the secondary transformers. Use all original washers and screws to close the housing. IHG 1500 | Version 2.02...
Step 2: If necessary, dismantle the devices into manage- able and usable components and components. Step 3: The device components and operating materials must be routed to the appropriate disposal rou- tes. IHG 1500 | Version 2.02...
- Always contact the manufacturer if you are unsure. - Type of device: Induction heating system IHG 1500 - Item number: 6400015 - Position number: 06 Tips and recommendations...
Emitted interference for industrial areas DIN EN 61000-6-4:2011-09 Electromagnetic compatibility (EMC) - Part 6-4: Generic Standards - Emitted interference for industrial areas Responsible for documentation: Kilian Stürmer, Dr.-Robert-Pfleger-Str. 26, D-96103 Hallstadt Hallstadt, 16.11.2018 ______________________ Kilian Stürmer CEO, Director IHG 1500 | Version 2.02...
Need help?
Do you have a question about the IHG 1500 and is the answer not in the manual?
Questions and answers