Advertisement
Quick Links
AGE: 14+
Do not mix old batteries with new ones,
or mix different types of batteries.
3.1 Press the rear battery module of the drone, then pull the lithium battery module out from the battery compartment. (Fig.C)
3.2 Plug the USB charging cable into the USB power socket. Then, connect the other end to the charging socket of the
Li-ion battery module. During charging, the LED light will be red. When charging is complete, the LED light will turn off
automatically. The charging time is approximately 120 minutes.
When the drone enters the low-pressure zone, the body light will flash slowly.
This indicates that the drone's battery is running low and it needs to return to the base immediately
1.Install the aircraft battery and the remote controller's battery.
Turn on the aircraft power switch and place the fuselage light
on the horizontal ground after it finishes flashing.
performed
specified
GT4131
(Forward/backward, left,
and right side flying.
Advertisement
Related Manuals for Electus Distribution GT4131
Summary of Contents for Electus Distribution GT4131
- Page 1 GT4131 AGE: 14+ (Forward/backward, left, and right side flying. Do not mix old batteries with new ones, or mix different types of batteries. 3.1 Press the rear battery module of the drone, then pull the lithium battery module out from the battery compartment. (Fig.C) 3.2 Plug the USB charging cable into the USB power socket.
- Page 2 Our product is guaranteed to be free from manufacturing defects for a period of 12 Months.If your product becomes defective during this period, Electus Distribution will repair, replace, or refund where a product is faulty; or not fit for intended purpose.
Need help?
Do you have a question about the GT4131 and is the answer not in the manual?
Questions and answers