Wall Mounting Installation - JML Instant Heater User Manual

WALL MOUNTING INSTALLATION

• The Instant Heater must be mounted horizontally only. If using the standard plug,
an electrician is not required for installation. A quali ed electrician is only required
if the Instant Heater is being hard-wired into the wall.
• DO NOT install the heater on a ammable surface.
• The lowest part of the heater must be located at or above a minimum height of
1.8m from ground level, so that the heater cannot be touched when in operation.
• When mounting, do not angle the face of the heater at higher than 90 degrees, or
lower than 45 degrees from the surface (see diagram on p6)
• NOTE: If this range of angles is exceeded, the heater will automatically switch o .
• Ensure the orientation is correct. The end with the cord and display panel should
be to the le -hand side.
• Keep the power cord away from the body of the heater, as the body will get hot
when the heater is in use.
• When mounting the heater, pay attention to the minimum safe distance between
the heater body and ammable surfaces.
• The heater should always have a minimum clearance of 0.3m from a ceiling and
adjacent walls.
•
When used outdoors, always use a weatherproof power outlet and a residual
current device (RCD).
•
Before drilling mounting holes, make sure there are no wires or water pipes behind
the wall onto which the heater is to be mounted.
• The heater must be installed using the mounting brackets provided.
• Fasten the brackets securely to the mounting surface and the back of the heater
using the nuts and bolts supplied.
• Fasten the heater securely onto the brackets using the nuts and bolts supplied.
• The brackets can be used to adjust the direction of the heater. Adjust the heater
angle by loosening the two bolts on the wall.