Advertisement
Quick Links
Lamps are set for 7" Water Column pressure on natural gas and 11" W.C. pressure for LP gas.
MODEL HK
DANGER
FIRE OR EXPLOSION HAZARD
If you smell gas:
• Shut off gas to appliance.
• Extinguish any open flame.
• If odor continues, leave the area immediately.
• After leaving the area, call your supplier or
fire department.
Failure to follow these instructions could result in fire or explosion,
THESE INSTRUCTIONS SHOULD BE LEFT WITH THE CONSUMER. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
All lamps are available with inverted or open flame burners. Replacement parts may be obtained through an authorized Everglow dealer
or visit www.mhponlinestore.com. To locate the nearest local dealer visit mhpgrills.com/where-to-buy/.
NOTE: In Canada, the installation shall be in accordance with: the current edition of CAN/CGA-8149.1 Natural gas
installation code or CAN/CGA-8149.2 Propane gas installation code, and all local codes where applicable.
GAS LAMPS INSTALLATION,
FOR OUTDOOR USE ONLY.
MODEL GG
FOR YOUR SAFETY
• Do not place combustible
materials near this appliance.
• Do not store or use gasoline
or other flammable vapors
and liquids in the vicinity
of this or any other appliance.
which could cause property damage, personal injury, or death
PARTS & MAINTENENCE
HK, GG and HJ SERIES
MODEL HJ
FOR YOUR SAFETY
The installation of this gas lamp
must conform with all local codes
or, in the absence of local codes,
with the latest edition of the
National Fuel Gas Code ANS 223.1
English
Advertisement
Summary of Contents for MHP Everglow HK Series
- Page 1 GAS LAMPS INSTALLATION, PARTS & MAINTENENCE HK, GG and HJ SERIES FOR OUTDOOR USE ONLY. Lamps are set for 7” Water Column pressure on natural gas and 11” W.C. pressure for LP gas. MODEL HK MODEL GG MODEL HJ DANGER FOR YOUR SAFETY FOR YOUR SAFETY FIRE OR EXPLOSION HAZARD...
- Page 2 STEP 4 Before filling in the hole, reduce your main gas supply line to a 1/4” male flare coupling (not provided by MHP). Connect the main gas supply line to the copper tubing in the lamp post using the attached 1/4” female flare coupling.
- Page 3 STEP 4 STEP 5 STEP 6 With gas turned off, After the mantles have Your MHP lamp is factory If flame extends above the Replace the glass by Remove the glass by Hold a lighted match up stopped burning, use...
- Page 4 If the flame extends beyond the above the mantle ring, turn the lamp OFF and contact your local gas company or an authorized MHP dealer. Ensure Proper Combustion: Do not block any air inlet or outlet vents to maintain proper combustion.
Need help?
Do you have a question about the Everglow HK Series and is the answer not in the manual?
Questions and answers