Summary of Contents for Performance Tool W50057
- Page 1 AUTO-DARKENING WELDING HELMET Item Number W50057 OWNER’S MANUAL WARNING! READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND WARNINGS BEFORE OPERATING THIS TOOL. FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE AND WILL VOID WARRANTY.
-
Page 2: Safety Guidelines - Definitions
SAFETY GUIDELINES / DEFINITIONS This instruction manual is intended for your benefit. Please read and follow the safety, installation, maintenance and troubleshooting steps described within to ensure your safety and satisfaction. The contents of this instruction manual are based upon the latest product information available at the time of publication. - Page 3 IMPORTANT SAFETY INFORMATION 3. Use personal protective equipment. Wear ANSI safety glasses or goggles and protective clothing to approved safety goggles. Protective equipment such protect your skin from radiation, burns and spatter. as dusk mask, non-skid safety shoes, hard hat, heavy Ensure that radiation from other welder’s arcs in duty work gloves or hearing protection used for ap- immediate area does not enter from behind the...
-
Page 4: Operation
OPERATION WARNING ARC Rays can injure protect the user from harmful UV/IR, eyes and burn skin. Before welding, no matter what shade filter is present. always inspect helmet and filter lens WARNING FUMES AND GASSES to be sure they are fitted properly, can be dangerous to your health. - Page 5 OPERATION CAUTION Always check the front welding filter, replace if it is worn cover lens of the Auto-darkening or damaged, scratched, cracked or filter, and make sure that they are pitted. Adjust shade state to fit the clean and no dirt is covering the sen- welding work by turning the knob sor on the front of the filter cartridge.
- Page 6 WARNING: If the welding helmet is void the warranty and expose the not used and/or stored, always keep user to the risk of personal injury. the helmet with filter sensors down- • Should the Auto-darkening Welding ward. Failure to do this may cause Helmets not darken upon striding an earlier batteries exhaustion.
-
Page 7: Care And Maintenance
CARE & MAINTENANCE WARNING: Replacement of any com- Auto-darkening Welding Filter. ponents and/or parts shall be original Store helmet and the auto-darkening from the manufacturer. Don’t immerse welding filter in dry and well-ventilated the lens in water or any other liquid. place. - Page 8 90 days from the date of purchase, provided that product is returned to place of purchase immediately after discovery of defect. After 90 days and up to one year from date of purchase, PERFORMANCE TOOL®...
Need help?
Do you have a question about the W50057 and is the answer not in the manual?
Questions and answers