Do you have a question about the EF-ARIS28 and is the answer not in the manual?
Questions and answers
Summary of Contents for Aristo EF-ARIS28
Page 1
ARISTO INSERT ELECTRIC FIREPLACE OWNERS MANUAL EF-ARIS28 EF-ARIS50 Model Numbers: AC 220-240V 50Hz 1400-1600W Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Failure to do so could WARNING result in fire, electric shock, or serious personal injury.
IMPORTANT SAFETY INFORMATION! WARNING When using electrical appliances basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: Read all instructions before using this heater. This heater is hot when in use. To avoid burning, do not touch hot surface. If provided, use ...
Preparation This product includes a GLASS panel! Always use extreme caution when using. Failure to do so could result in personal injury or property damage. Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Check the parts list to make sure nothing is missing.
PRODUCT DIMENSIONS Model Number 28" 7.3" 27.5" 25.2" 6.5" 25.1" 19.7" EF-ARIS28 71.1cm 18.4cm 69.8cm 64cm 16.5cm 63.8cm 50cm 49" 7.3" 23.6" 46.2" 6.5" 46" 13" EF-ARIS50 125cm 18.4cm 60cm 117.5cm 16.5cm 117.2cm 33cm Installation and Assembly Your appliance is a recessed and/or mantel installed appliance. Select a suitable location that is not susceptible to moisture and is away from drapes, furniture and high traffic areas.
Page 5
Pre-installation Built-in Due to the many different materials used on different walls, it is highly recommended that you consult your local builder before you install this appliance. A. Select a location that is not prone to moisture and is located at least 36” (94.1cm) away from combustible materials such as curtain drapes, furniture, bedding, paper, etc.
Page 6
Front Glass Panel Removal A. Remove the screws from the top of the glass. Set the screws aside. (Fig. 1) B. Carefully lift the front glass up and away from the appliance. Place it face down on a soft, non-abrasive surface. C.
Page 7
Log-set / Crystal / Pebble Ember Installation Glass front must be removed and the appliance must be installed in its final location before the log-set / crystal / pebble are installed. (See above section for glass removal) Remove the log-set (E) from the package, put it to the fireplace designed place. Fig 3-1. To switch to crystals.
Operation Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Failure to do so could result in electric shock, fire, serious injury, or death. Power Plug the power cord into a 220-240V 50Hz outlet (see IMPORTANT SAFETY INFORMATION on Pages 2 and 3).
Page 9
Control Panel / Remote Control Operation BUTTON FUNCTION ACTION & INDICATION ON: Enables control panel functions and 1. Press once. Indicator light turns on. remote control. Turns on flame effect. Power turns on. All functions enabled. OFF: Disables control panel functions and 2.
Page 10
P 1. Press once. Indicator lights up. TEMPERATURE button: Turns heater on and off. Temperature goes to 18 ℃ 2. Press again. until desired setting is NOTE: Press & Hold the button for 5 seconds, the temperature setting will switch from ℃ to ℉. reached.
Page 11
Flame speed button:Controls the speed 1. Press once. Flame speed gets changing. of the flame.There are 3 flame speed 2. Press again until desired setting is settings: 01 (slowest), 02 (Medium), 03 reached. Display shows the setting. (fastest). SPEED The Default setting is 03 (fastest speed) Flame color button: Makes the color 1.
When the heater is first turned on, a slight odour may be present. This is normal NOTICE and should not occur again unless the heater is not used for a long period of time. To improve operation, aim the remote control at the front of the fireplace. DO NOT NOTICE press the buttons too quickly.
Page 13
Plastic: Wipe gently with a slightly damp cloth and a mild solution of dish soap and warm water. NEVER use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface. Maintenance Risk of electric shock! DO NOT OPEN any panels. No user-serviceable parts inside! ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning, performing maintenance, or moving this fireplace.
Need help?
Do you have a question about the EF-ARIS28 and is the answer not in the manual?
Questions and answers