Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dowell iPack C6.5
Summary of Contents for Dowell iPack C6.5
- Page 1 DOWELL SYSTEM INSTALLATION TIPS iPack – Deye...
-
Page 2: Table Of Contents
Content Introduction ............3 Installation preparation ......4 iPack operation .......... 5 Deye operation .......... 7 Adaptation verification ......11... -
Page 3: Introduction
User Manual for iPack with Deye inverter INTRODUCTION iPack C6.5 has been compatible to deye hybrid inverters. Compatible hybrid inverters model are as follows： SUN-3.6K-SG01/03LP1-EU • • SUN-5K-SG01/03LP1-EU SUN-5K-SG01LP1-US • SUN-6K-SG01LP1-US • SUN-7.6K-SG01LP1-US/EU • SUN-8K-SG01LP1-US/EU • SUN-5-8K-SG01LP1 • SUN-8K-SG04LP3 •... -
Page 4: Installation Preparation
User Manual for iPack with Deye inverter 1. INSTALLATION PREPARATION 1.1 Read the installation chapter in the user manual of the Deye inverter and operate it according to the actual site requirements. The screenshots of the installation chapter are as follows: About “Battery connection”: Communication interface is BMS CAN •... -
Page 5: Ipack Operation
User Manual for iPack with Deye inverter 2. IPACK OPERATION Read the iPack C6.5 user manual carefully, check if all spare parts are the same as what it mentioned in manual, and take out crystal terminator, cable sets etc, Especially crystal terminators which are used to insert at Link in and out as per manual. - Page 6 User Manual for iPack with Deye inverter Connect one battery...
-
Page 7: Deye Operation
User Manual for iPack with Deye inverter 3. DEYE OPERATION This is the key step for matching the inverter with the battery, please follow the steps shown in the figure. Turn on the inverter, click the gear icon in the upper right corner of the figure below •... - Page 8 User Manual for iPack with Deye inverter 3.1 In the Battery setting page. • choose “Lithium” for “Batt Mode”. “Battery capacity” is set according to the actual battery capacity connected to the inverter. “Max. A charge/discharge” is set according to the actual working conditions. Disable “Active battery”.
- Page 9 User Manual for iPack with Deye inverter Click to go to the next page. “Lithium Mode” is 00, other parameters are set • according to the actual needs. It is recommended not to be lower than the setting value in the following figure. The Shutdown is not less than 10%. In the Advanced setting page.
- Page 10 User Manual for iPack with Deye inverter...
-
Page 11: Adaptation Verification
User Manual for iPack with Deye inverter 4. ADAPTATION VERIFICATION You will see the battery SOC information at the inverter's main screen by clicking the battery icon, once system installation. And check the details about battery in Li-BMS. - Page 12 User Manual for iPack with Deye inverter If the liBMS interface displays Dowell's relevant information, it indicates that communication between the battery and inverter has been established. After system running in half hour to see if the system is working well.
- Page 13 User Manual for iPack with Deye inverter Note1:After the system is running, confirm again whether the parameter selection in the settings is correct. Note2:Once a malfunction occurs, immediately report and troubleshoot the issue, shut down the entire system (Not just batteries) until the problem is confirmed and put into operation.
Need help?
Do you have a question about the iPack C6.5 and is the answer not in the manual?
Questions and answers