Electron BASELINE TWIST MILKY LED Installation Manual

BASELINE TWIST MILKY LED
Baseline TWIST Milky LED is a fully encapsulated, both Vertical & Horizontal bending flexible linear LED.
Ÿ
Available in Pro or Standard Version.
Ÿ
Material: Silicone
Ÿ
Bin Step: Monochromatic White LEDs Silicone: 2SDCM
Ÿ
L70B10>50000Hrs
Ÿ
Available in IP67 protection rate.
Ÿ
CRI>90 for 2700/3000/3500/4000K
Ÿ
Possibility to create straight or curved lines.
Ÿ
Can be used both indoor and outdoor.
Ÿ
Dot free lighting effect.
Ÿ
IK 08 Protection.
Ÿ
Can ideally be used with surface aluminium profile.
Ÿ
Max connection length:
Monochromatic: 5 meters single supply
Ÿ
UV Resistant
Chemical Resistant
> Please verify the contents of the packages.
> Please read the instructions entirely before starting installation.
> Be sure power is turned off before installing the system.
Warnings: risk of product damage
> BASELINE TWIST can be twisted within 200mm bending diameter.
> BASELINE TWIST shall not be bent sharply as it may cause product damage.
> During the installation, the BASELINE TWIST
Dimensions
Cutting points: every 50mm
Please confirm with the C
sign on the rear side of the modules
Note: Cutting the product without the appropriate endcap and tools by a non-authorized person
will result to a loss of the IP protection, causing water leakage and failure.
Bending
Horizontal bending
Light Surface
Do not hang
can not be: Dropped Bent at a 90 angle or bent at all Sagging/Hanging down ,
16mm
15mm
15mm
16mm
Do not Bend too tight
Light Surface
ELECTRON SA, PROFESSIONAL LIGHTING SYSTEMS
68 Antiohias Str, N. Philadelphia, 143 41 Athens, Greece, Tel. +30 210 2584240, Fax. +30 210 2584245, info@electron.gr, www.electron.gr
o
,
Vertical bending
Light Surface
Installation note
BASELINE TWIST must be installed with two people. One to press
the luminaire into the profile and the other to hold the reel and
unroll it while keeping the
Installation Manual
BASELINE TWIST flex body straight.
1