Figure 3-3 Hailo-8 Module Information - StarFive VisionFive 2 Quick Start Manual

| 3 - Compilation
$ sudo cp ./linux/pcie/51-hailo-udev.rules /etc/udev/rules.d/
$ sudo udevadm control --reload-rules && sudo udevadm trigger
Note:
<VERSION> is the same as the current HailoRT-driver version, please check and confirm on your own. In
this example, it is 4.19.0.
b. After the above operations, you need to restart HailoRT-driver. The following command can be used to verify
whether HailoRT and HailoRT-driver are compiled and installed properly:
$ hailortcli fw-control identify
You can view the connected Hailo-8 module information:

Figure 3-3 Hailo-8 Module Information

Tappas
Run the following command to enter the top-level directory of Tappas source code:
$ cd tappas/
$ ./install.sh --skip-hailort --target-platform vf2
$ source /home/user/.hailo/tappas/tappas_env
www.starfivetech.com © 2018-2024 StarFive Technology
All rights reserved
12