Advertisement
Quick Links
Rack Mounting Guide
Table of Contents
Overview
Front Panel LED Indicators
Rail Installation
•
Rail Package
•
Installing inner slides
•
Installing outer slides
•
Installing slide assemblies to the Rack
Chassis installation
Removing Chassis from the rack
www.idrive.com/bare-metal-recovery/
01
Advertisement
Summary of Contents for IDrive BMR Pro
- Page 1 Rack Mounting Guide Table of Contents Overview Front Panel LED Indicators Rail Installation • Rail Package • Installing inner slides • Installing outer slides • Installing slide assemblies to the Rack Chassis installation Removing Chassis from the rack www.idrive.com/bare-metal-recovery/...
- Page 2 Locate the right inner slide (the slide that will be used on the right side of chassis when facing the front panel of the chassis). Align the four square holes on the right inner slide against the hooks on the right side of the chassis as shown below. www.idrive.com/bare-metal-recovery/...
- Page 3 Attach the slides to the rack with M5 screws and washers. Repeat steps from 1 to 4 for the left outer slide. Depending on your rack structure, short brackets might not be required to attach to the outer slide. www.idrive.com/bare-metal-recovery/...
- Page 4 Removing Chassis from the rack Release the locking clips that are circled on the rails to remove the chassis from the rack, as shown in Hooks the figure below. M4 Screw Square Holes M4 Screw www.idrive.com/bare-metal-recovery/...
Need help?
Do you have a question about the BMR Pro and is the answer not in the manual?
Questions and answers