Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Torpedo7 Synchro
Summary of Contents for Torpedo7 Synchro
- Page 1 Torpedo7 Synchro HOME ASSEMBLY INSTRUCTIONS...
- Page 2 Torpedo7 store and book in with our workshop for assembly, free of charge. Alternatively, if you do not have a Torpedo7 store close by, any local bike store will be able to assist in building your bike. A service fee may apply.
- Page 3 Remove the bike from the box, carefully remove all Ensure the fork is in the correct orientation, with packaging and set aside any parts so you have a the brake facing forwards. Unclip the brake noodle clear working space. Have someone to assist while to allow the wheel to pass through.
- Page 4 Re-attach the front brake noodle and ensure it is Use the 5mm allen key to loosen the cable clamp. properly seated. Whilst pulling the right brake lever Pull the cable through to adjust the brake until the to engage the pads with the rim. Loosen the 5mm pads are around 3-5mm away from the rim and not allen bolt holding the brake pad and align the pad contacting the tyre.
- Page 5 (Fig 1) Check the handlebar alignment, adjust by loosening To adjust the shifting, lift the rear wheel off the the 6mm stem bolts (fig 1) then re-secure these ground and rotate the cranks, use the right-hand stem bolts. Tighten the clamps for the brake lever, gear selector to change gear one by one, to get to gear selector, bell and reflectors using the 5mm gear.
- Page 6 With the right-hand shifter put the rear gears into Once in 1 gear check and adjust the low limit . Rotate the cranks and use the left-hand gear screw until it is just touching the derailleur stopper. selector to change gear one by one, to get to 1 This may not require adjustment so do a visual gear.
Need help?
Do you have a question about the Synchro and is the answer not in the manual?
Questions and answers