Advertisement
Baridi Visor Cooker Hood Extractor Fan
60cm - DH107 Black / DH108 Stainless
Steel
Model No. DH107, DH108
Thank you for purchasing a Dellonda product. Manufactured to a high standard, this product will,
if used according to these instructions, and properly maintained, give you years of trouble free performance.
www.dellonda.co.uk
DH107, DH108 Issue:3 24/10/24
Advertisement
Table of Contents
Related Manuals for baridi DH107
Summary of Contents for baridi DH107
- Page 1 Baridi Visor Cooker Hood Extractor Fan 60cm - DH107 Black / DH108 Stainless Steel Model No. DH107, DH108 Thank you for purchasing a Dellonda product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.
-
Page 2: Specification
Refer to Warning: instruction manual Surface Specification Airflow: 220m³/h Nett Weight: Cable Length: 1.5m Power: Colour: DH107 Black, DH108 Stainless Product Dimensions: 600 x 492 x 80mm Control: 3-Speed Push Button Supply: 220V~240V 50Hz Design: Visor Type: Wall Mounted Electrical Class:... -
Page 3: Installation (Vent Outside)
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. -
Page 4: Operation
• Insert the plug into the holes. • Insert the screws into the plugs and tight. • Put up the cooker hood onto the fixed screws. • Then place the supplied screws into the two holes of inside the hood, then tighten screws to the hood onto the wall. fig.4 •... -
Page 5: Troubleshooting
TROUBLESHOOTING Fault Cause Solution Light on but motor does not work Fan switch turned off Select a fan switch position Fan switch failed Contact service centre Motor failed Contact service centre Light does not work, motor does not work House fuses blown Reset/replace fuses Mains cable loose or disconnected Refit mains power cable to power outlet. - Page 6 • NOTE: Make sure the filter is securely locked. • Otherwise, it could loosen and be dangerous. • When the activated carbon filter is fitted, the suction power will be lowered. • BULB REPLACEMENT • The bulb must be replaced by the manufacturer, its service agent or similarly qualified persons.
Need help?
Do you have a question about the DH107 and is the answer not in the manual?
Questions and answers