BSH 687923 Kit Instructions

KIT INSTRUCTIONS
THERMADOR PRO HARMONY 30-INCH, NG AND LP GAS RANGES
EN SERVICE KIT 687923 FOR KNOB / AIRFLOW ENHANCEMENT
The information provided in this document is intended for trained, qualified personnel only. The proper function and the safety of the appliance can be affected by an improper repair,
and even serious threats to life or physical condition may arise. BSH Home Appliances Corporation is not liable for damages caused by improper repairs performed by unauthorized
parties. Local codes and standards apply and must be observed. Contact the Technical Support Team for further assistance.
DESCRIPTION
NOTE: First verify the range installation is correct before installing
the service kit .
The Knob / Airflow Enhancement Service Kit is for situations where the control
knobs may get warm after long periods of range use. Although the knobs do not
exceed the allowable limit for surface temperature,
comfort by maximizing the airflow, thereby reducing heat build-up
COMPONENTS INCLUDED IN SERVICE KIT
•
Kit instructions (1)
•
Control board kit (1) – includes control board, jumper harness, instructions
•
Air diverter (1)
•
Crossflow blower fan & retaining bracket assembly (1)
•
Lowback (1) NOTE: Only for range installations using the lowback. Not
needed for ranges using the high backguard or island trim.
•
Drill-point T-10 screws (4)
TOOLS AND SUPPLIES NEEDED
•
Power driver / drill
•
T-10, T-20, and T-30 drivers
•
1/8 inch standard or stainless steel drill bit
•
Protective eyewear and clothes
•
Service manual
•
Other tools per service manual that may be needed for the disassembly and
installation of range components
Copyright by BSH Home Appliances Corporation
INSTALLATION INSTRUCTIONS
NOTE: Follow all warnings and precautions in this document, as well as in the
NOTE: Follow the disassembly and installation instructions contained in the
1.
this service kit enhances
2.
.
3.
4.
1901 Main St., Irvine, CA 92614
Document material number: 9000742832
58300000162832 ABZ EN B
service manual for this range.
service manual for range components.
Turn off gas supply and electrical power to the range.
Gain access to the back of the range, and then remove the backguard
(high backguard, lowback, or island trim).
Remove the back panel.
Replace control board:
a. Remove range-top components (burners, grates, griddle, maintop, and
heat shield) in order to gain access to the range-top chassis floor.
See Figure 1.
b. Remove existing control board, and replace it with the supplied control
board, per service manual and control board kit instructions.
Figure 1: Range-top Components
FEBRUARY, 2012
Page 1/3
800 444-9091