Republic of China and international copyright laws. TRADEMARKS C-Media, the C-Media Logo, Xear 3D, Xear 3D Logo, Speaker Shifter, Smart Jack, and Smart Audio Jack, Middleware are trademarks of C-Media Electronics Inc. in Republic of China andor other countries.
Page 3
CM6530N+CM7104 USB Audio Controller Demo Board User’s Guide v1.00 Revision Notes Revision Date Description 2023/04/21 First draft Worldwide Solution That Touch People’s Hearts! - 3 -...
SECTION 1 OVERVIEW 1.1 Introduction The CM6530N is a low power USB 2.0 audio controller builds in 8051 for flexible applications. Accompany with ultra low power codec makes it suitable for low power headset, notebook/mobile docking and microphone applications. The internal 8051 can also be developed to different applications, such as Android Phone or idevice Accessories with special functions, such as HID buttons or LED control.
Page 6
CM6530N+CM7104 USB Audio Controller Demo Board User’s Guide v1.00 the DSP core for wide use case flexibility. Two digital audio interfaces are provided, supporting I S/PCM/TDM audio formats. Two differential analog microphone inputs and up to four digital microphone inputs can accept audio signals from multiple microphone or line input sources.
CM6530N+CM7104 USB Audio Controller Demo Board User’s Guide v1.00 1.2 Demo Board Contents The CM6530N+CM7104 USB Audio controller demo board has several hardware features. With each feature’s description in figure, the feature’s location can be clearly identified. MIC In Line Out...
CM6530N+CM7104 USB Audio Controller Demo Board User’s Guide v1.00 SECTION 2 GETTING STARTED 2.1 Board as USB Audio Device Connect the demo board to the host by plugging the USB core with a type C connector, as shown below. Type C USB connector (J12) 2.2 Playback / Recording Functions...
CM6530N+CM7104 USB Audio Controller Demo Board User’s Guide v1.00 2.2.2 EARPHONE (J20) EARPHONE(J20) is output from the class D AMP. Have jack detect function with input. 2.2.3 RCA Output R_ch (J21) & L_ch (J22) RCA Output R_ch (J21) & L_ch (J22) from the Class D AMP.
CM6530N+CM7104 USB Audio Controller Demo Board User’s Guide v1.00 2.3.2 Function Switch (SW6) Switch the CM7104 DSP ON/OFF by GPIO_15). 2.3.3 EQ Effect Switch (SW1) Switch the EQ function by GPIO_12& GPIO_13). 2.3.4 TEST Pin (J14) Description When firmware crash, short this pin could Test enable firmware recover mode.
CM6530N+CM7104 USB Audio Controller Demo Board User’s Guide v1.00 2.3.13 Type C VBUS to USB5V (J12) Description Symbol Connect J12 pin1-2 for system USB5V 2.3.14 DMIC1 (J8) & DMIC2 (J11) Description Symbol DMIC1 (J8) Pin1 DBVDD 3.3V for DMIC power...
Need help?
Do you have a question about the CM6530N and is the answer not in the manual?
Questions and answers