Firstech Drone XC Wiring Schematic

410X290mm
By Firstech LLC Version 1.0
8104MAUCL002200
Type 2 Installation - Standalone
Power & Data Connections
(DATA) CANL *
Optional Connection
(DATA) CANH *
Optional Connection
(+) Ignition (Required)
(-) Ground (Required)
+12V Battery (Required)
Type 1 Installation - DATA-to-DATA
Power & Data Connections
(DATA) CANL *
Optional Connection
(DATA) CANH *
Optional Connection
(+) Ignition (Not Required)
(-) Ground (Required)
+12V Battery (Required)
To Compatible Firstech CM (Required)
CM-X
Product Activation Required
Install and activate at www.myfirstech.com/activation
Drone XC Wiring Schematic
Install Drone XC as a standalone dash camera system with LTE and GPS
OR add to a compatible Firstech remote start/security system.
Visit https://www.myfirstech.com/installer-guides for full installation guides.
5
White
4
Brown
3
Green
2
Black
1
Red
UART Connection Cable
(Required for Type 1 Install)
5
White
4
Brown
3
Green
2
Black
1
Red
2.5mm Rear Camera Port
(Extension Included)
*Optional CAN Connections
CANH & CANL connections of the Drone XC
are optional and available for use in either
Type 1 or Type 2 Installations.
2.5mm Rear Camera Port
(Extension Included)
Harness Trim I
(Removed for clarity)
Control Side
(Bottom when installed)
Drone XC-LTE | 2023
Harness Trim II
( Optional Long Version )
Windshield Side
(Top when installed)