Datalogic FALCON 4400 SERIES Installation Instructions

Removing Strap Studs/Bumpers
To attach the printer adapter to a Falcon, you must
remove the strap studs, as well as the optional strap
stud bumpers, if present.
1. Loosen and pull off the strap stud bumpers (if
present). If necessary, pry off using a screwdriver.
2. Use a 5/64" Allen wrench (included with the
printer adapter kit) to loosen and remove each
Strap Stud.
Attaching the Serial Printer Adapter
©2007 Datalogic Mobile, Inc.
Falcon
Serial Printer Adapter

Installation Instructions

The Falcon 4400 Series Serial Printer Adapter attaches to the
bottom of a Falcon 44XX unit and allows you to connect and
print directly to a printer.
Strap Stud
Bumpers
Once you have removed the strap studs, attach the
adapter to the Falcon by sliding into place and
tightening the thumbscrews on the adapter.
R44-2828 (Rev B)
®
4400 Series
Strap Studs
09/07