Replacement Element Installation Replacement Parts Heater Coverage Areas General Notes Maintenance Instructions Trouble Shooting Location Suggestions Warranty SAVE THIS MANUAL FOR FUTURE REFERENCE PROUDLY MADE IN USA Alfresco Heating 30 Pamaron Way, Suite A, Novato CA 94949 Phone: 707-345-4000 : 888-WARM-GLO (888-927-6456)
Page 2
888-WARM-GLO WARNINGS READ ALL INSTRUCTIONS BEFORE INSTALLING/OPERATING HEATER. Unit must be installed and serviced by a licensed electrician. Unit may be a source of possible shock. NEVER attempt to service the heater without disconnecting its power source. Source of possible ignition. WARNING: If not installed, operated and maintained in accordance with the manufacturer’s instructions, this product can expose you to chemicals including nickel, which are known to the State of California to cause cancer.
888-WARM-GLO INSTALLATION INSTRUCTIONS This heater must be permanently installed and hard wired by a licensed electrician in accordance with local electrical codes. Assembly procedure must be performed with no electrical power to unit. Step 1: Check the heater's UL/CUL/CE label for proper voltage. Step 2: All electrical connections must comply with the National Electric Code (NEC) and local codes.
888-WARM-GLO MOUNTING INSTRUCTIONS These models may be chain or bracket mounted to any ceiling or horizontal surface. Installation must be such that 18" (45.7cm) minimum clearance is maintained around the heater on all four sides and 36" (91.4cm) directly in front. A minimum of 6"...
888-WARM-GLO ELEMENT INSTALLATION INSTRUCTIONS ( VISIT INFRATECH.COM FOR INSTALLATION AND REPLACEMENT VIDEO INSTRUCTIONS ) • Disconnect power to the heater • Unscrew and take off the end covers. • Remove the screw, pivot the element clips, and carefully position the new quartz tube(s) in place. Close the element clips that secure the tube to the heater and reinstall the screw.
888-WARM-GLO SINGLE ELEMENT AREAS COVERED (FEET) MODEL WATTS MOUNTING HEIGHT AVERAGE COLD PROTECTED C-1512 SS 1,500 6' - 7' (1.8m - 2.1m) 5' x 5' (1.5m x 1.5m) 3' x 3' (0.91m x 0.91m) 7' x 7' (2.1m x 2.1m) C-2024 SS 2,000 7' - 8' (2.1m - 2.4m)
888-WARM-GLO TROUBLESHOOTING PROBLEM WHAT TO DO Heater does not glow • Check supply voltage to confirm it matches voltage of heating element. Low heat output • A 240V element connected to 110V or 208V will warm, but not glow orange or generate sufficient heat for typical applications (Matching your voltage is extremely important).
This Warranty Registration Card must be returned within thirty days of purchase to properly activate your warranty. This information is for our internal use only. Alfresco Heating 30 Pamaron Way, Suite A, Novato CA 94949 Phone: 707-345-4000 : 888-WARM-GLO (888-927-6456)
This manual is also suitable for:
Infratech comfort cd seriesInfratech comfort c-1512 ssInfratech comfort c-2024 ssInfratech comfort c-2624 ssInfratech comfort c-3024 ssInfratech comfort c-4024 ss...
Show all
Need help?
Do you have a question about the Infratech Comfort C Series and is the answer not in the manual?
Questions and answers