Table of Contents
Advertisement
9) IDE3 / IDE4 (IDE3 / IDE4 Connector, RAID/ATA133)
The red stripe of the ribbon cable must be the same side with the Pin1. If you wish to use IDE3 and
IDE4, please use it in unity with BIOS (either RAID or ATA133). Then, install the correct driver to
have proper operation. For details, please refer to the GigaRAID manual.
10) SATA0_SB / SATA1_SB (Serial ATA Connector, Controlled by nVIDIA nForce3 250)
11) SATA0_SII / SATA1_SII (Serial ATA Connector, Controlled by SiI3512))
You can connect the Serial ATA device to this connector. If you wish to use RAID function, please
use it in unity with BIOS and install the correct driver to have proper operation.
These SATA connectors support hot plug function.
GA-K8NSNXP Motherboard
39
40
SATA0_SB / SATA1_SB
1
7
SATA0_SII / SATA1_SII
7
1
- 26 -
1
IDE4
IDE3
2
Pin No.
Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
GND
Advertisement
Table of Contents
