Gigabyte GA-EP45C-UD3 User Manual page 26

8) SATA2_0/1/2/3/4/5 (SATA 3Gb/s Connectorss, Controlled by ICH10, Orange)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device.
9) GSATA2_0/1 (SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2, Purple)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The GIGABYTE SATA2 controller
supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions
on configuring a RAID array.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
• A RAID 5 configuration requires at least three hard drives. (The total number of hard
drives does not have to be an even number.)
• A RAID 10 configuration requires at least four hard drives and the total number of hard
drives must be an even number.
Only for GA-EP45C-UD3.
GA-EP45C-UD3R/UD3 Motherboard
SATA2_4 SATA2_2
7
1
SATA2_5 SATA2_3
GSATA2_0
1
7
1 7
GSATA2_1
- 26 -
Pin No.
1
2
SATA2_0
3
1
4
7
5
SATA2_1
6
7
Please connect the L-shaped end
of the SATA 3Gb/s cable to your
SATA hard drive.
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Definition
GND
TXP
TXN
GND
RXN
RXP
GND