Summary of Contents for AcSiP EK-AI6108L-S
- Page 1 EK-AI6108L-S User Guide AcSiP Technology Corp. www.acsip.com.tw Doc No : 912-17002 Ver. : B AcSiP Technology Corp www.acsip.com.tw Date: 2024/10/15...
-
Page 2: Functional Description
Functional Description USB Type-C Connector (DC Power in) DC-DC 3.3V Regulator Nucleo / Arduino Nucleo / Arduino Connections Connections (CN7,CN10) (CN8,CN9) GPIOs AI6108Lx Module SMA Connector AcSiP Technology Corp www.acsip.com.tw... - Page 3 DC Power Jumper Jumper Settings vs. Schematic Ensure that jumper H11 on the EK-AI6108Lx-S is not fitted. See above photos for correct jumper settings. AcSiP Technology Corp www.acsip.com.tw...
-
Page 4: Pinout Diagram
SDIO_CLK SPI_SCK Pins Legend： GPIO10 SDIO_D3 SDIO_D3 SPI_CS GPIO9 GPIO8 Module Pin Name SDIO_D2 SDIO_D2 VDDIO POWER SDIO_D1 SDIO_D1 SPI_INT SDIO_D0 SDIO_D0 SPI_MISO SDIO Interface Pins SPI Interface Pins Control Pins *Serial Pins *Pending software support AcSiP Technology Corp www.acsip.com.tw... - Page 5 USB port is not able to supply sufficient power. Note that if power is supplied via the USB-C connector then JP6 on the Nucleo must be removed. The Nucleo must still be connected to the PC via micro-USB connector CN1 in order to use the debug interface. AcSiP Technology Corp www.acsip.com.tw...
- Page 6 USB port is not able to supply sufficient power. Note that if power is supplied via the USB-C connector then JP1 on the Nucleo must be removed. The Nucleo must still be connected to the PC via micro-USB connector CN15 in order to use the debug interface. AcSiP Technology Corp www.acsip.com.tw...
- Page 7 USB port is not able to supply sufficient power. Note that if power is supplied via the USB-C connector then JP3 on the Nucleo must be removed. The Nucleo must still be connected to the PC via micro-USB connector CN1 in order to use the debug interface. AcSiP Technology Corp www.acsip.com.tw...
- Page 8 Reference Platforms Raspberry Pi 4B EK-AI6108Lx-S needs to be connected to the Raspberry Pi 4B through an adapter board, as shown in the image below. EK-AI6108Lx-S Adapter Board Raspberry Pi 4B AcSiP Technology Corp www.acsip.com.tw...
- Page 9 Reference Platforms Raspberry Pi 4B EK-AI6108Lx-S Raspberry Pi 4B Adapter board ∅2.5mm x 11mm Standoff AcSiP Technology Corp www.acsip.com.tw...
- Page 10 Connect the RJ45 Ethernet cable to the Ethernet port. • Once power is applied, it should take the device around 60 seconds to boot up and be operational. Ethernet No need to connect USB-C JP1: Interface switch jumper setting USB-C Power Supply AcSiP Technology Corp www.acsip.com.tw...
-
Page 11: Antenna Specifications
Antenna Specifications AcSiP Technology Corp www.acsip.com.tw...
Need help?
Do you have a question about the EK-AI6108L-S and is the answer not in the manual?
Questions and answers