Table of Contents
Advertisement
CPU Hyper-Threading
Enabled
Enables CPU Hyper Threading Feature. Please note that this feature is only working
for operating system with multi processors mode supported. (Default value)
Disabled
Disables CPU Hyper Threading.
Limit CPUID Max. to 3
Enabled
Limit CPUID Maximum value to 3 when use older OS like NT4.
Disabled
Disables CPUID Limit for windows XP. (Default value)
2-3
Integrated Peripherals
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
On-Chip SATA
x SATA Port0 Configure as
SATA Port1 Configure as
USB Controller
USB 2.0 Controller
USB Keyboard Support
USB Mouse Support
AC97 Audio
Onboard H/W LAN
Onboard LAN Boot ROM
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
: Move
Enter: Select
F5: Previous Values
On-Chip Primary PCI IDE
Enabled
Disabled
On-Chip Secondary PCI IDE
Enabled
Disabled
On-chip SATA
Disabled
Auto
Manual
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Integrated Peripherals
[Enabled]
[Enabled]
[Auto]
SATA Port0
SATA Port1
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Auto]
[Enabled]
[Disabled]
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
3
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Enable onboard 1st channel IDE port. (Default value)
Disable onboard 1st channel IDE port.
Enable onboard 2nd channel IDE port. (Default value)
Disable onboard 2nd channel IDE port.
Disable SATA controller.
When there is no device to be plugged in IDE1 or IDE2, SATA controller
will remap to IDE controller. (Default value)
Set SATA Mode manually.
- 35 -
Menu Level
If a hard disk
controller card is
used, set at Disabled
[Enabled]
Enable on-chip IDE
Port
[Disabled]
Disable on-chip IDE
Port
F10: Save
ESC: Exit
F7: Optimized Defaults
Item Help
F1: General Help
BIOS Setup
Advertisement
Table of Contents
