Table of Contents
Advertisement
Quick Links
PATIO HEATERS
MODEL#: F210017-A1/ F210017-B2/ F210017-C3
Gas-Fired Outdoor Infrared Patio Heater
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference
WARNING: For Outdoor Use Only.
Installation and service must be performed by a
qualified installer, service agency, or the gas
supplier.
DANGER
If you smell gas:
Shut off gas to the appliance.
Extinguish any open flame.
If odor continues,
and immediately call your gas supplier or fire
department.
DANGER
WARNING:
Improper installation, adjustment, alteration, service or maintenance can cause injury or
property damage. Read the installation, operating, and maintenance instructions thoroughly
before installing or servicing this equipment.
keep away from the appliance
This appliance can produce carbon monoxide which has no odor.
Using it in an enclosed space can kill you.
Never use this appliance in an enclosed space such as a camper,
tent, car or home.
WARNING
Do not store or use gasoline, or other
flammable vapors and liquids, in the
vicinity of this or any other
appliance. An propane cylinder not
connected for use shall not be stored
in the vicinity of this or any other
appliance.
CARBON MONOXIDE HAZARD
Extr eme ly
hot, DO NOT
touc h
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Afterglow F210017-A1
- Page 1 PATIO HEATERS Extr eme ly hot, DO NOT touc h MODEL#: F210017-A1/ F210017-B2/ F210017-C3 Gas-Fired Outdoor Infrared Patio Heater INSTALLER: Leave this manual with the appliance. CONSUMER: Retain this manual for future reference WARNING: For Outdoor Use Only. Installation and service must be performed by a qualified installer, service agency, or the gas supplier.
-
Page 2: Important Safety Information
IMPORTANT SAFETY INFORMATION The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1 NFPA 54; National Fuel Gas Code; Natural Gas and Propane Installation Code, CSA B149.1; or Propane Storage and Handling Code, CSA B149.2, as applicable. -
Page 3: Specifications
IMPORTANT SAFETY INFORMATION (About Propane Gas) The propane gas supply cylinder to be used must be constructed and marked in accordance with the U.S. Department of Transportation (D.O.T.) Specifications for propane Gas Cylinders, or the Standard for Cylinders, Spheres and Tubes for Transportation of Dangerous Goods and Commission, CAN/CSA-B339, as applicable. -
Page 4: Package Contents
PACKAGE CONTENTS PART DESCRIPTION QUANTITY Metal shield Glass fixture Wide glass Narrow glass Base Door Weather cover Foot glider (PRE-ASSEMBLED) Hood... -
Page 5: Safety Information
HARDWARE CONTENTS (shown actual size) Bolt (M6 x 5 mm) Caster Caster with locking device Ground fixer Phillips screwdriver Qty. 24 Qty. 2 Qty. 2 Qty. 4 Qty. 1 SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. - Page 6 SAFETY INFORMATION DANGER during the combustion process. This product is designed to produce extremely minute, non-hazardous amounts of CO if used and maintained in accordance with all warnings and instructions. Do not block air flow into or out of the heater. fatigue and possibly death.
-
Page 7: Burn Hazard
SAFETY INFORMATION WARNING WARNING BURN HAZARD Certain materials or items, when stored under the heater, will be subjected to radiant heat and use. could be seriously damaged. CAUTION SERVICE SAFETY WARNING odorant is normally added to help detect leaks and can be described as a “rotten egg” smell. The odorant can fade over time so leaking gas is not always detectable by smell alone. - Page 8 ASSEMBLY INSTRUCTIONS 1. Side place the product base (E) on a non-abrasive flat Figure 2 surface to prevent scratching, unscrew the foot gliders (H) and remove from the base (E). Line up the hole on the ground fixer (DD) with the corresponding holes on the base (E), then insert the bolt on foot glider (H) into the holes and hand tighten them clockwise.
- Page 9 ASSEMBLY INSTRUCTIONS 3. Insert the four narrow glass (D) into the "L" clips which Figure 4 have been welded together with table top, then attach them with bolts (AA) using the Phillips screwdriver (EE) (See Figure 4). Note: DO NOT tighten the bolts completely. Hardware Used Bolts ( Phillips screwdriver x 1...
- Page 10 ASSEMBLY INSTRUCTIONS 6. With the help of another person, cover and clamp the Figure 7 three wide glass (C) with metal shield (A) carefully and tenderly, insert the fourth wide glass (C) into the "L" clips in the metal shield (A) firstly, then insert the bottom of wide glass (C) into the "L"...
- Page 11 ASSEMBLY INSTRUCTIONS 8. Place the gas cylinder into the cylinder holder. Secure Figure 9 the cylinder by tightening clockwise the retention point found on the cylinder holder, so that the cylinder cannot move from side to side or fall down. Connect the regulator, screw the black handle clockwise to tighten, turn the black handle counterclockwise to regulator...
- Page 12 OPERATION INSTRUCTIONS BATTERY Make sure the control knob is in the “OFF” position. Unscrew the push button cap on the ignitor module located on the control panel to access the battery compartment. The ignitor module requires one AAA size battery. BATTERY IS NOT INCLUDED. WARNING: 1.
-
Page 13: Lighting Instructions
OPERATION INSTRUCTIONS gas valve / regulator hose connection (Figure 14) inlet tube / bellows connection (Figure 15) To perform a leak test: 1. Make 2~3 oz. of leak solution by mixing one part liquid dishwasher detergent and three parts water. Noted: make sure control knob is “OFF”. 2. -
Page 14: Care And Maintenance
OPERATION INSTRUCTIONS Observe Flame Height When Lit: The burner will display blue and yellow flames. These flames should be a blue / yellow color between 15~20 in. height (See Figure 17). These flames should not be yellow or produce thick smoke. This would indicate an obstruction of airflow through the burners. The flames should be blue with straight yellow tops. -
Page 15: Troubleshooting
Troubleshooting Problem Possible cuase Corrective action Wait until gas cylinder The gas cylinder is frosted over. warms up and becomes An opening is blocked. unfrosted. The burner The control knob is not in the Clear the blockage. will not ignite. “ON”... -
Page 16: Warranty
WARRANTY Heater Burner, all mechanical parts and fittings to control panel and burner assembly, and all patio heater tops that are not cast aluminum are warranted for a period of one (1) year from original date of purchase, against defects in material and or workmanship. Rust is not covered. Frames Frames are warranted to be free from defects in materials and workmanship for a period of one (1) year.
Need help?
Do you have a question about the F210017-A1 and is the answer not in the manual?
Questions and answers