Advertisement
Quick Links
How to Remove and Reposition a 2GIG Smoke Sensor Model 2GIG-SMKT3-345
Description
This page shows how to remove and reposition a 2GIG Smoke Sensor Model 2GIG-SMKT3-
345
Please read through the directions in its entirety before commencing.
Preparation
***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the
panel on test mode through
1. Tap [Home]
2. Tap [Place on Test]
3. Enter your expiration date and time
4. Enter your password
5. Tap [Yes-Proceed]
Parts Required
1. A Phillips screwdriver
2. A thin sharp knife
Removal of Smoke Sensor
myadt.ca. After logging in:
Advertisement
Summary of Contents for TELUS 2GIG
- Page 1 How to Remove and Reposition a 2GIG Smoke Sensor Model 2GIG-SMKT3-345 Description This page shows how to remove and reposition a 2GIG Smoke Sensor Model 2GIG-SMKT3- Please read through the directions in its entirety before commencing. Preparation ***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the panel on test mode through myadt.ca.
- Page 2 1. Grab the face of the smoke detector and twist to the left to release from the back plate 2. Arm and disarm the alarm to clear panel alert 3. Determine if the back plate is attached with adhesive tape or screwed in a.
- Page 3 ***If the alert does not clear or if the panel sensor shows tamper, walk through the steps above once more. It could be the sensor cover is not on properly***...
Need help?
Do you have a question about the 2GIG and is the answer not in the manual?
Questions and answers