Summary of Contents for Ideal Boilers imax xtra F80
Page 1
When replacing any part on this appliance, use only spare parts that you can be assured conform to the safety and performance specification that we require. Do not use reconditioned or copy parts that have not been clearly authorised by Ideal Boilers.
Important Notes • This appliance must not be operated without xtra the casing correctly fitted and forming an adequate seal. Natural Gas only PI No. 0063 BR 3123 • Do not store objects around or on the boiler, and keep access clear at all times.
Page 3
BOILER CONTROLS / DISPLAY MASTER MODULE CONTROL PANEL A. Burner switch B. Pressure gauge C. Display D. Reset button RESET E. Mode button xtra F . Step button G . Store button H. + button (to increase MODE STEP STORE values) - button (to decrease values)
Page 4
CONTROL OF WATER TEMPERATURE AND SYSTEM TYPES The water temperatures and system types are factory preset but may be adjusted. The following settings can be changed. DHW Temperature (optional) DHW System CH System Flow Temperature Parameter settings and limits are listed below. Parameter mode is entered from standby mode by pressing the 'mode' button once.
Page 5
To shut Down the Boiler C o n d e n s a t e D r a i n 1. For short periods The condensate drain must not be modified or blocked. Set the external controls to OFF. Wait 10 minutes and then Blockage of the condensate drain, caused by debris or freezing, isolate the mains supply to the boiler.
Page 8
The right is therefore reserved to vary specification without notice. Tel: 01482 498376 Ideal Boilers, P.O. Box 103, National Ave, Kingston Upon Hull, HU5 4JN. Tel. www.idealboilers.com 01482 492251 Fax. 01482 448858. Registration No. London 322 137.
Need help?
Do you have a question about the imax xtra F80 and is the answer not in the manual?
Questions and answers