Summary of Contents for StoreYourBoard SWIVEL BIKE PRO
- Page 1 INSTALLATION GUIDE S W I V E L B I K E P RO S CAN M E FO R IN S TALL V IDEO Questions or Concerns? Contact us at: info@storeyourboard.com...
- Page 2 Quantity: 1 The Swivel Bike Pro is intended for the storage of bicycles only. Do not use it for any other WARNING! The Swivel Bike Pro is NOT intended for use by any person under the age of 18 purpose.
-
Page 3: Recommended Tools
INSTALLATION Mark Stud Locations • Use a stud finder to locate a wall stud where you want to mount the rack. • Mark the stud location with a pencil for reference. Main Subassembly Qty: 1 Measure Bike Length • Wheel your bike on it’s back tire. Your bike should be vertical at this point with both tires resting against the wall, inline with your stud that you referenced in step 1. - Page 4 INSTALLATION Mount the Bottom Struts • Place one end of the Bottom Strut (C) onto the threaded stud on the Tire Support (B) and fasten it with an M6 nylon locking nut (H) using a 10mm wrench. Take note of the correct orientation of the Bottom Struts (C) as seen in figure 6.1.
- Page 5 INSTALLATION Mount the Rear Tire Catch • Load the bike onto the rack with the handlebars turned in the desired direction. To make the bike sit naturally, the rack should be swiveled slightly off to the same side as the handlebars are facing with the rear tire falling a couple inches from the centerline.
Need help?
Do you have a question about the SWIVEL BIKE PRO and is the answer not in the manual?
Questions and answers