Microsoft MN700 - Wireless 802.11g Base Station Router User Manual page 9

Antenna
Optional
stand
The front of the base station has seven status lights. The following table describes the
behavior of each light.
Status light On
Power Green: Ready
Orange: Resetting,
restoring factory defaults,
or upgrading firmware
Modem Modem connected and
turned on
Wireless Radio enabled
Ethernet Ethernet device
port (4) connected and on
*If the Power light is blinking, reset the base station by using the procedure described
later in this chapter.
Power, Modem, and
Wireless lights
Ethernet port lights, which
correspond to the Ethernet
ports on the back of the
base station
Off Blinking
Not receiving Error*
power
Modem off or not Data being sent or received
connected through the modem
Radio disabled Data being sent or received
wirelessly
Ethernet device off Data being sent or received
or not connected over Ethernet connection
Chapter 1: Introduction 3