MSC 64(67) Annex 4 IEC 60872-3 COPY RIGHT Copyright Kelvin Hughes Ltd. 2002, 2003 All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, translated or stored in any form or by any means, without the written permission of Kelvin Hughes Limited.
KH 2026 AMENDMENT RECORD When an amendment is incorporated into this handbook, the details should be recorded below. If the equipment has been modified, the modification number is shown on the Amendment instruction page. Date Inserted Initials Date Inserted Initials 10/03 03/04 Issue 2, Amdt 2...
Page 4
KH 2026 THIS PAGE INTENTIONALLY BLANK July 03 Issue 2...
Page 5
KH 2026 CONTENTS Pre lim i nary Pages Title Page Conformity & Copyright Page Amendment Record Page Contents (this page) Electric Shock Resuscitation Warning Pages Caution Page Preface List of Abbreviations IN TRO DUC TION OP ER ATING IN FOR MA TION CHAPTER 1 - OPERATING INSTRUCTIONS CHAPTER 2 - RADAR PLOTTING AIDS - EPA CHAPTER 3 - RADAR PLOTTING AIDS - ATA/ARPA...
Page 6
KH 2026 ELECTRIC SHOCK RESUSCITATION REMOVE OBVIOUS SHOUT FOR HELP. SWITCH OBSTRUCTION TO REMOVE FROM DANGER. OFF ELECTRICITY IF POSSIBLE. BREATHING. If casualty is not breathing start Do this immediately. If not possible, don't waste time Safeguard yourself when removing casualty from hazard. resuscitation at once.
KH 2026 SAFETY WARN INGS CD-0845 WARNING THIS EQUIPMENT IS NOT FITTED WITH SAFETY INTERLOCKS. LETHAL VOLTAGES ARE PRESENT WHEN THE UNITS ARE OPEN AND EXPOSED. BEFORE REMOVING ANY SUB-UNIT OR PCB, ALL SUPPLIES MUST BE SWITCHED OFF. WARNING ENSURE THAT THE DISPLAY IS SWITCHED OFF PRIOR TO CLEANING THE SCREEN. OTHERWISE STATIC BUILD-UP MAY PRODUCE ELECTRICAL DISCHARGES WHICH, IN EXTREME CASES, COULD BE HAZARDOUS.
Page 8
KH 2026 SAFETY WARN INGS AN TENNA RA DI A TION HAZ ARD INJURY CAN RESULT FROM EXPOSURE TO THE MAIN BEAM OF A RADAR ANTENNA AT A DISTANCE FROM THE CENTRAL FRONT FACE, OF LESS THAN: 1.3m (X-Band) Antenna: 3.0 metres 1.8m (X-Band) Antenna: 2.3 metres 2.4m (X-Band) Antenna: 1.5 metres 2.9m (S-Band) Antenna: 1.1 metres...
Page 9
KH 2026 SAFETY WARN INGS Mains Voltage All Kelvin Hughes equipment is supplied with Mains Voltage set for 220V, unless stated otherwise on labels attached to the equipment. S-Band Tuning It may be necessary to re-tune the transmitter when changing the pulse length.
Page 10
KH 2026 CAU TION HAN DLING OF ELEC TRO STATIC-SENSITIVE SEMI CON DUC TOR DE VICES Certain semiconductor devices used in the equipment are liable to damage due to static voltage. Observe the following precautions when handling these devices in their unterminated state, or sub-units containing these devices: Persons removing sub-units from an equipment containing these devices must be earthed by a wrist strap and a resistor at the point provided on the equipment.
Page 11
KH 2026 PREFACE Manta is designed to be flexible and expandable making it ideal for use in Integrated Bridge Systems (IBS), as well as for standalone Radar Systems and Electronic Chart Display Information Systems (ECDIS). When used in standalone systems the Manta Display is dedicated for use as either a Radar Display or as an ECDIS Display.
KH 2026 LIST OF AB BRE VI A TIONS Acquire RADAR Radio Detection And Ranging Adjust Random Access Memory Automatic Frequency Control RATS Rate Aided Tracking System ARPA Automatic Radar Plotting Aid RCGA Radar Control Gate Array Audible Radar Interswitch Unit RM(R) Relative Motion, Relative Trails Bow Crossing Range...
KH 2026, Introduction Contents INTRODUCTION TABLE OF CONTENTS Page • INTRODUCTION • OPERATION • DIS PLAY TYPES AND PLOT TING AIDS • MAPPING • STRUC TURE OF THIS MAN UAL • MANTA DIS PLAYS - CON TROLS AND INDICATORS • Desk Top Dis play •...
Page 14
KH 2026, Introduction Contents ILLUSTRATIONS Page • Figure 1 - Desk Top Display • Figure 2 - Console Mounted Console Display • Figure 3 - Flush Console Mounted Display • Figure 4 - Single Display with single Upmast Transmitter/Receiver and Antenna. •...
(2) Automatic Tracking Aid (ATA) - providing manual warnings, target information and Ownship navigation data. acquisition and automatic tracking. Relative The Manta series equipment is designed for use as Motion RM(R), True Motion TM(T) and Relative either a panel mounted Console or a Desk Mounted Motion RM(T) modes incorporate True Motion Display with a separate Processor Unit.
KH 2026, Introduction MANTA DISPLAYS - CONTROLS AND Console Mounted and Flush Console Mounted Displays INDICATORS The Console Mounted Display comprises a plastic bezel moulding, fitted around the flat screen display. The Manta Radar Displays use flat screen technology and are available in three sizes (17", 20" and 23"), with The Flush Mounted Console Display has a flat metal the option of desk mounting, console mounting, or flush bezel surround and is designed to fit flush with the...
KH 2026, Introduction DISPLAY FACILITIES Variable Range Marker The Variable Range Markers (VRM1 & VRM2) are For information on how to select any facility on the shown on the radar display as dashed rings (colour display, refer to Operating Information, Chapter 1. coded;...
KH 2026, Introduction RADAR PLOTTING AIDS SYSTEM CONFIGURATIONS The Manta System can be configured in a number of Electronic Plotting Aid (EPA) different ways. Typical examples are shown in the figures at the end of this Introduction. The Electronic Plotting Aid (EPA) is a manual plotting system equivalent to, but superior than, a reflection The control and status interface between the Displays plotter.
KH 2026, Introduction TECHNICAL OVERVIEW The basic Manta Radar consists of a Manta Display The cable used for the PS2 interface must generally be and associated Radar Processor Unit, together with less than 3 metres long, in order to meet the Radar Transceivers/Antennas and Interface Units as specification for the interface.
(3) Four configurable NMEA serial interfaces are speed antennas at 40 rpm. provided. These are opto-isolated from the T he Kelvin Hughes MkIV, M kV and MkVI internal circuitry of the Radar Processor Unit. All transceivers/antennas can only be interfaced to the four interfaces can be configured for RS232 Radar Processor Unit via the parallel control lines.
The PCB converts the signal into azimuth pulses display or to a Kelvin Hughes ECDIS. The RIU and produces a heading line pulse for the display. uses the CAN bus interface only, so where the...
Page 22
KH 2026, Introduction DIS PLAY SYS TEM SPEC I FI CA TION The following table contains a Summary of Data for all Manta Displays Manta 1700 Manta 2300 Manta 2000 Display 17-inch TFT LCD Colour Flat Panel 20-inch TFT LCD Colour Flat Panel 23-inch TFT LCD Colour Flat Panel PPI minimum diameter - 250 mm PPI minimum diameter - 295 mm...
Page 23
KH 2026, Introduction Manta 1700 Manta 2300 Manta 2000 Gyro Input All types stepper, synchro, “M” type with 90:1, 180:1 and 360:1 ratios. IEC 1162-2 High Speed Serial Gyro Interface. Primary Single Axis 100, 200, 400, Pulses/nm, Speed Input Manual, VHW Secondary Fixed Track Target Speed Input...
Page 24
KH 2026, Introduction Manta 1700 Manta 2300 Manta 2000 Power Supplies 110V nominal, 220V nominal (50-60Hz) - Single Phase. 115/380/440V 3 phase with optional transformer. Power corruption protected default parameters. Standard: 4 x NMEA Input (RS422/RS232) Interfacing 1 x NMEA Output RS422 3 x NMEA Output RS232 Serial Trackerball Input PS/2 Trackerball Input...
Page 25
KH 2026, Introduction Manta 1700 Manta 2300 Manta 2000 Orientation: Landscape Display Size: Height: 408 mm (17-inch) (desktop) 457 mm (20-inch) 480 mm (23-inch) Width: 514 mm (17-inch) 538 mm (20-inch) 615 mm (23-inch) Depth: 606 mm (17-inch) 608 mm (20-inch) 615 mm (23-inch) Display Size: Height:...
KH 2026, Introduction X BAND ANTENNA KELVIN HUGHES UPMAST Tx Tx MONITOR RADAR GYRO PROCESSOR DGPS UNIT SOUND POWER 110/220V AC VIDEO POWER CD-5343 Figure 4 - Single Display with single Upmast Transmitter/Receiver and Antenna. X BAND ANTENNA KELVIN HUGHES...
KH 2026, Introduction S BAND HIGH SPEED ANTENNA X BAND HIGH SPEED ANTENNA KELVIN HUGHES KELVIN HUGHES HSC 10kW UPMAST Tx/Rx HSC 30kW UPMAST Tx/Rx TX MONITOR Tx MONITOR 38-CORE CABLE TRANSMITTER INTERFACE UNIT AERIAL POWER 220/440V AC POWER 110/220V AC...
KH 2026, Introduction PARALLEL/ CAN BUS CONTROL ANTENNA AZIMUTH/HEADING LINE TO OTHER VIDEO DISPLAYS/PROCESSORS SYNC PARALLEL/ CAN BUS CONTROL AZIMUTH/HEADING LINE RADAR TRANSCEIVER VIDEO SYNC INTERFACE UNITS (IF REQUIRED) PARALLEL/ SHIPS MAINS/ POWER CAN BUS CONTROL PROCESSOR UNIT AZIMUTH/HEADING LINE PARALLEL/ CAN BUS CONTROL VIDEO...
Page 30
KH 2026, Introduction THIS PAGE INTENTIONALLY BLANK July 03 Issue 2...
Page 31
KH 2026, Introduction Index Introduction Index ARPA Radar Plotting Aids Rain Automatic Radar Plotting Aid Range Automatic Tracking Aid (ATA) Range Scales/Rings and Pulse Lengths Range Scales DISPLAY FACILITIES Relative Motion (True Trails) Display System Specification Relative Motion RM(R) Display Types Relative Motion RM(T) Screen Modes of Operation Electronic Bearing Line...
Page 32
KH 2026, Introduction Index THIS PAGE INTENTIONALLY BLANK July 03 Issue 2...
Page 33
KH 2026 Record Pages INSTALLATION RECORD TO BE COM PLETED ON IN STAL LA TION NAME OF VESSEL: .................. DISPLAY TYPE (1) Manta ........ SERIAL. NO..... DISPLAY TYPE (2) Manta ........ SERIAL. NO..... DISPLAY TYPE (3) Manta ........ SERIAL.
Page 35
KH 2026 Record Pages DE FAULT SET TINGS FACTORY RANGE CUSTOMER SETTINGS SETTINGS RANGE 0.25 - 96nm RINGS (ON/OFF) ON/OFF ON/OFF EBL1/EBL2 VRM1/VRM2 ON/OFF VECTOR TIME 15min 1 - 30min NORM NORM/NORM VECTOR MODE REVERSED DAY/NIGHT DAY/NIGHT ON/OFF TRAILS ON/OFF TRAILS TIME 3min 0.75 - 99min...
Page 36
KH 2026 Record Pages FACTORY RANGE CUSTOMER SETTINGS SETTINGS 0 - 9 GAIN CONTROL CURSOR MODE Range/Bearing Range/Bearing or TCPA LOW/HIGH CURSOR PARKING ENHANCE NORM NORM/ENH CORRELATION OFF, IR or SC/SC 0.1 - 6nm TCPA 15min 1 - 60min LEVELS Maximum 0 to Maximum LOG, Man or Dop...
Need help?
Do you have a question about the Manta Series and is the answer not in the manual?
Questions and answers