Summary of Contents for Volt VTR-50-PBK
- Page 1 INSTALLATION INSTRUCTIONS VOLT LOW VOLTAGE POWER SUPPLY ® ITEM: VTR-50-PBK 1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)
- Page 2 INSTALLATION INSTRUCTIONS VOLT Low Voltage Power Supply ® VTR-50-PBK IMPORTANT: PLEASE READ BEFORE INSTALLATION Low voltage installation and maintenance is safe and presents no risk for electric shock injury. However, there are regulations that may apply and that should be followed by installers. The following safety points may or may not be included in these regulations - the installer is responsible for ensuring a compliant installation.
- Page 3 IMPORTANT: PLEASE READ BEFORE INSTALLATION WARNING: Risk of Electric Shock. Install power unit 5 feet (1.5 m) or more from a pool, spa, or fountain. Where the power unit is installed (a) indoors within 10 feet (3.05 m) of a pool, spa, or fountain or (b) outdoors, connect power unit to a receptacle protected by a GFCI.
- Page 4 INSTALLATION INSTRUCTIONS VOLT Low Voltage Power Supply ® VTR-50-PBK DETERMINE WIRE GAUGE What gauge cable do I need in order to run my Landscape Lighting System? Will you be using Holagen or LED fixtures? BOTH HALOGEN Is the length of your...
-
Page 5: Package Contents
PACKAGE CONTENTS A. (1) Power Supply PARTS REQUIRED (SOLD SEPARATELY) A. (1) Wall Anchor C. (1) Mounting Accessory B. (1) Screw PRODUCT DIMENSIONS 3.36” 1.65” 3.23” 1” 3” 3.15” 5.12” 3.71” 813.978.3700 • customersupport@voltlighting.com • www.voltlighting.com... - Page 6 VOLT Low Voltage Power Supply ® VTR-50-PBK This power supply can be mounted to a wall or a stake. Please refer to Option A for wall mounting and Option B for stake mounting. INSTALL POWER SUPPLY TO WALL (OPTION A)
- Page 7 INSTALL STAKE (OPTION B) Determine your desired location Board for mounting the power supply. Hammer the stake (sold separately) into the ground until flange of stake is flush to grade. To avoid damage to the stake, place a board on top of the stake Stake (Sold while hammering.
-
Page 8: Remove Cover
INSTALLATION INSTRUCTIONS VOLT Low Voltage Power Supply ® VTR-50-PBK OPEN DOOR Open the door of the power supply. Power Supply Door REMOVE COVER Remove the bottom cover of the Power Supply power supply. Bottom cover 813.978.3700 • customersupport@voltlighting.com • www.voltlighting.com... -
Page 9: Connect Wires
CONNECT WIRES Power Supply 1. Take out terminal blocks from the power supply. 2. Open the levers on the Lever terminal blocks. 3. Insert one side of the supply Terminal wire into the COM and the Block other into the 15V terminal block. - Page 10 INSTALLATION INSTRUCTIONS VOLT Low Voltage Power Supply ® VTR-50-PBK CONNECT TO WALL OUTLET AND TEST POWER SUPPLY Power Supply Insert the plug to the wall outlet. Push the ON/OFF switch on the side of the ON/OFF Switch power supply to turn on the Wall Outlet fixtures.
- Page 11 813.978.3700 • customersupport@voltlighting.com • www.voltlighting.com...
- Page 12 1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST) Specifications and product details subject to change without notice. © Copyright 2024, VOLT Lighting, Lutz FL USA 33549 • All rights reserved. ® customersupport@voltlighting.com • www.voltlighting.com...
Need help?
Do you have a question about the VTR-50-PBK and is the answer not in the manual?
Questions and answers