Advertisement
Quick Links
STP-MLD+
Installation and Owner's Manual
Manual #
Revision
Date
Changes from previous revision
400439002
3
Sept. 2014 Changed MLD+AG description to 85% ethanol
Franklin Fueling Systems • 3760 Marsh Rd. • Madison, WI 53718 USA
Tel: +1 608 838 8786 • 800 225 9787 • Fax: +1 608 838 6433 • www.franklinfueling.com
Advertisement
Summary of Contents for FE PETRO STP-MLD+
- Page 1 STP-MLD+ Installation and Owner’s Manual Manual # Revision Date Changes from previous revision 400439002 Sept. 2014 Changed MLD+AG description to 85% ethanol Franklin Fueling Systems • 3760 Marsh Rd. • Madison, WI 53718 USA Tel: +1 608 838 8786 • 800 225 9787 • Fax: +1 608 838 6433 • www.franklinfueling.com...
-
Page 2: Important Safety Messages
Thermal expansion can cause pressure to build up in the product lines. FE Petro ®... -
Page 3: Installation Instructions
3 GPH or greater. If two EPA requirements 280.41(b) & 280.44(a) for automatic leak STP-MLD+s are in parallel, a leak of 6 detection in pressurized piping. After installation, the user GPH will be the smallest leak that will of the leak detector must monitor system delivery levels to be capable of being detected. - Page 4 (if already installed). detector from operating correctly. 2. Tag and lock out electrical circuit breakers so they ® The FE Petro STP/IST’s have two are not turned on accidentally. Caution labeled ports: one for the syphon...
- Page 5 11. Purge remaining air from the system as follows: 12. Turn the pump off at the load center, relieve the Turn on power at the load center, and dispense line pressure, and then remove the pipe plug in enough gasoline from the dispenser farthest the shear-valve.
- Page 6 Continue to Mechanical line leak detectors are devices that are drain until there is no more product draining. Turn subject to wear with usage. However, FE Petro ® the submersible pump on at the dispenser and...
-
Page 7: Troubleshooting
Continue to the next step. testing cycle 4. Test for thermal contraction per FE Petro ® e. There must be less than 12 feet of static head Technical Bulletin TB-001. If thermal contraction in the system has been verified, continue with the next step. - Page 8 ©2014 FFS 400439002 Rev3...
Need help?
Do you have a question about the STP-MLD+ and is the answer not in the manual?
Questions and answers