Casio PRIVIA PX-735 User Manual page 31

3.
Keeping side panel
the side panel with side of the digital piano.
(3-1) Push side panel A in the direction indicated by
the black arrow in the illustration to align the side
panel so there is as little space as possible between
its top edge A and the bottom of the top panel of
the digital piano ( ).
(3-2) After alignment is complete, stand side panel A
straight up so it is firmly against the side of the
digital piano.
Top panel of the digital piano
IMPORTANT!
• When performing step (3-1) above, make sure that
you position side panel A so its top edge reaches
the bottom of the digital piano top panel. If it does
not, you will not be able to stand side panel A
straight up in step (3-2).
4.
Perform the following steps to secure the side
panel to the digital piano.
(4-1) Press downwards on side panel A to ensure that it
is inserted as far as it will go into the bracket on
the side of the digital piano.
(4-2) Use the D screws to secure side panel A to the
digital piano.
(4-1)
(4-2)
D
Bracket
A
tilted at an angle, align
(3-2)
A
(3-1)
L
-(b)
A
5.
L
Insert foam piece
as shown in the illustration.
A
IMPORTANT!
• The foam piece should be located directly under the
two screw holes ( ) in the side panel.
6.
Repeat steps 2 through 5 to attach side panel
B
to the other side of the digital piano.
7.
C
Attach back panel
Use the four screws
K
connectors .
• Insert the four joint connectors at the four locations
C
on back panel . The holes in the joint connectors
should be aligned with the holes in the back panel.
C
• Lift up back panel
screw holes in the side panels, and then tighten the
D
screws .
• If you have trouble inserting the screws
K
joint connector holes, use a screwdriver to rotate
the joint connector (
*CAUTION
• Never try to force the screws! Forcing the screws D
to turn while the joint connector K holes are not
aligned correctly can strip the screw threads.
• Partially tighten the screws on one side of the Back
panel C and then fully tighten the screws on the
other side.
• Next, fully tighten the screws that you partially
tightened.
K
A
C
D
Assembling the Stand
A
under side panel
-(c)
L
-(c)
A B
to side panels and
D
and four joint
so its screw holes align with the
D
into the
in Figure).
K
B
D
E-29
.