Festive P051505 Assembly And Usage Instructions

INF
TYPE
P051505 Issue 1
Assembly and Usage Instructions for: P051505 –
120CM INFINITY NUTCRACKER
BOX CONTENTS
1 X 120CM NUTCRACKER. 1 x TRANSFORMER
1 X MOUNTING BASE (SEE SEPARATE OUTDOOR INSTRUCTIONS SHEET
FOR INCLUDED FITTINGS)
UNPACKING OF ITEM
PLEASE BE CAREFUL WHEN UNPACKING ITEM AND FITTINGS
TAKE EXTRA CARE WHEN CUTTING PACKAGING AWAY FROM THE
TRANSFORMER LEAD, ALWAYS CUT AWAY FROM THE CABLE!
CHECK THAT YOU HAVE ALL PARTS AND FITTINGS FOR OUTDOOR USE
BEFORE YOU ASSEMBLE THE ITEM!
PLEASE RETAIN THE PACKAGING FOR STORAGE
ASSEMBLY INSTRUCTIONS
ON EACH MOUNTING BOARD YOU WILL NOTICE SOME HOLES, YOU
WILL USE THESE TO MATCH UP ON THE INFINITY ITEM WHICH HAS 2
HOLES, PLEASE MATCH THESE HOLES UP ON THE MOUNTING BOARD.
ON THE INFINITY ITEM THERE WILL BE 2 HOLES AT THE BOTTOM OF
EACH SIDE, MATCH THEM UP WIITH THE MOUNTING BOARD HOLES.
FIRSTLY YOU NEED TO INSERT THE INFINITY ITEM INTO THE
MOUNTING BOARD MAKING SURE THAT THE HOLES MATCH UP.
IF YOU ARE HAVING DIFFICULTY GETTING THE ITEM INTO THE
MOUNTING BASE, LINE UP THE EDGE OF THE INFINITY ITEM WITH THE
MOUNTING BOARD AND SQUEEZE THE FOAM TOGETHER, THIS SHOULD
THEN ALLOW YOU TO PUSH THE ITEM INTO THE GROOVE IN THE
MOUNTING BOARD FOR A TIGHT FIT.
DON'T FORGET TO MATCH THE HOLES UP.
REPEAT THIS PROCESS FOR THE NEXT SIDE OF THE ITEM.
NEXT USE THE SUPPLIED SCREWS WITH WING NUTS, THESE NEED TO
GO THROUGH THE ITEM AND THE MOUNTING BOARD, ONCE THROUGH,
TIGHTEN THE WING NUTS.
FOR OUTDOOR USE, PLEASE USE THE OUTDOOR INSTRUCTIONS, THESE
ARE ON A SEPARATE SHEET!