Page 1
INTELBRAS WC 3000 Hardware Information and Specifications INTELBRAS S.A. http://www.Intelbras.com.br...
Page 2
Preface INTELBRAS WC 3000 Series Access Controllers Hardware Information and Specifications describes product models, technical specifications, ports, and LEDs of the WC 3000 series access controllers. This preface includes the following topics about the documentation: Audience. Conventions. ...
Page 3
Symbols Convention Description An alert that calls attention to important information that if not understood or followed WARNING! can result in personal injury. An alert that calls attention to important information that if not understood or followed CAUTION: can result in data loss, data corruption, or damage to hardware or software. An alert that calls attention to essential information.
Product overview Product models This document is applicable to the WC 3000 series access controllers. Table1-1 describes the WC 3000 series access controller models. Table1-1 WC 3000 series access controller models Product series Product code Model Remarks WC 3010 WC 3010...
Page 6
Memory 2GB DDR4 4GB DDR4 Storage media 8GB eMMC memory 8GB eMMC memory Dual power supplies Rated voltage range: 100 to 240 VAC AC power supply Rated voltage range: 100 to 240 VAC @ 50 @ 50 or 60 Hz or 60 Hz System power 12.1 W to 29.5 W...
WC 3010 Front and rear views Figure2-4 Front view (1) 100/1000BASE-T autosensing Ethernet ports 1 to (2) 10GBASE-R-SFP+ ports 9 and 10 (3) 2.5G/1000BASE-T autosensing Ethernet ports 11 (4) USB port and 12 (5) Console port (6) Reset button (RESET) Figure2-5 Rear view (1) AC-input power receptacle (2) Grounding screw...
WC 3020 Front and rear views Figure2-7 Front view (1) 100/1000BASE-T autosensing Ethernet ports 1 to (2) 10GBASE-R-SFP+ ports 9 and 10 (3) 2.5G/1000BASE-T autosensing Ethernet ports 11 (4) USB port and 12 (5) Console port (6) Reset button (RESET) Figure2-8 Rear view (1) AC-input power receptacles (2) Grounding screw...
All device models NOTE: USB devices from different vendors vary in compatibilities and drivers. INTELBRAS does not guarantee correct operation of USB devices from other vendors on the device. If a USB device fails to operate on the device, replace it with one from another vendor.
Page 10
NOTE: As a best practice, use INTELBRAS transceiver modules for the device. The INTELBRAS transceiver modules are subject to change over time. For the most recent list of INTELBRAS transceiver modules, contact your INTELBRAS Support or marketing staff.
Flashing green (0.5 The system is operating correctly. A critical alarm has occurred, such as a power alarm, fan tray Steady red alarm, high temperature alarm, or software missing alarm. The device has not started up. SFP+ port LED Table3-10 10GBASE-R-SFP+ port LED description for the WC 3010 or WC 3020 LED mark Status Description...
100/1000BASE-T autosensing Ethernet port LED Table3-12 Description for the 100/1000BASE-T autosensing Ethernet port LEDs on the WC 3010, WC 3020. LED mark Status Description Steady yellow A 100 Mbps link is present on the port. The port is receiving or sending data at Flashing yellow 100 Mbps.
Airflow direction WC 3010 The device provides airflow from the left and right WC 3000 series sides to the rear side. See Figure4-2. WC 3020 Figure4-1 Airflow from the other three sides to the right side through the device chassis...
Need help?
Do you have a question about the WC 3000 Series and is the answer not in the manual?
Questions and answers