How To Enable Voice Over Ip On Your Network; How To Configure Upnp; How To Use A Router As An Access Point - Cisco SE1500 User Manual

Linksys E-Series
How to enable Voice over IP on your
network
Do I need to configure Voice over IP? VoIP (Voice over Internet Protocol) is a
technology for using the Internet as an interface for telephone communications
To use VoIP, you need to get an account with a VoIP service provider The VoIP
service provider typically provides you with a telephone adapter (TA) that
connects to your network If you do not use your network to make phone calls,
you don't need to change the default settings
The SIP (Session Initiation Protocol) ALG (Application Layer Gateway) feature
allows SIP packets, used by some VOIP service providers, to traverse (go
through) your router's firewall
To configure the router for VoIP:
Administration > Management
1. Log into the browser-based utility (see "How to open the browser-based
utility" on page 21)
2. Click the Administration tab, then click the Management page
3. If your VoIP service uses SIP, select Enabled next to SIP ALG
– OR –
If your VoIP service uses other NAT traversal solutions such as STUN
(Session Traversal Utilities for NAT), TURN (Traversal Using Relay NAT), or
ICE (Interactive Connectivity Establishment), select Disabled (default)
NOTE
You may need to contact your VoIP service provider to determine
the type of NAT traversal configuration they use

How to configure UPnP

What is UPnP? UPnP (Universal Plug and Play) allows devices connected
to a network to discover each other and automatically create working
configurations Examples of UPnP-capable devices include web cameras,
online gaming applications, and VoIP devices UPnP is enabled by default
To configure UPnP:
Administration > Management
1. Log into the browser-based utility (see "How to open the browser-based
utility" on page 21)
2. Click the Administration tab, then click the Management page
3. To use UPnP, select Enabled (default) next to UPnP Otherwise, select
Disabled
4. To allow changing router settings while using UPnP, select Enabled
(default) next to Allow Users to Configure Otherwise, select Disabled
5. To prevent local network users from disabling your Internet connection
through UPnP, select Disabled (default) next to Allow Users to Disable
Internet Access Otherwise, select Enabled

How to use a router as an access point

How can I use my old router as an access point? If you have a large area to
cover with your wireless signal, or if part of your home has weak signals due to
interference, you can use your old router to extend the range of your wireless
network This is a complex process, so this procedure assumes that you have
some networking knowledge
TIP
Check the documentation for your old router Some brands of
routers include either a switch on the outside of the case or a
software option to convert it to an access point If either of these
options is available, follow your old router's instructions to convert
it to an access point
Setting Up: Advanced
30