Strand TD90001 Manual

1. Introduction
Congratulations and thank you for purchasing this LED warn-ing light. All devices that we commercialise comply with the safety regulations valid at the time of
purchase and, in gen-eral, are safe provided they are used for the intended use. Observe the following instructions to avoid possible risks, damages or
malfunctions.
These Operating and Safety Instructions are included with the Led Warning Light. They contain important information on product handling. Please read the
instruction manual carefully, in particular the safety instructions, before using the LED warning light. This particularly applies to the safety instructions.
Failure to follow these operating instructions can result in serious injury or damage to the Led Warning Light. Keep the instruction manual in case you need to use
it in the future. If you give the LED warning light to another person, make sure it is accompanied by this instruction manual.
2. Contents of packaging
• 1 x LED warning light
• 1 power supply unit for 230 V socket (AC/DC)
• 1 power supply unit for 12 V car use (DC)
• 1 magnetic connector hub
• 1 USB charging cable
• 1 set of Operating Instructions & Safety Instructions
3. Range of Use
The LED warning light acts as an additional warning for hazard areas. However, it does not replace measures to secure hazard areas as per
traffic regulations.
The LED warning light is not suitable as conventional house-hold lighting.
4. Product details
Front
On/Off button
Pattern select button
16 LED
You can also use the magnet to attach the LED warning light to any metal surface. A securing eye is also featured to hang the LED warning light up.
5. Content of packaging
Ladeadadapter 230 V AC/DC
6. Recharging the LED warning light
Turn off all lights before charging.
The LED warning light can be recharged using the supplied 12 V car charger or the 230 V mains charger .
The battery needs to be charged before using it for the first time. Con-nect the magnetic connector hub to the LED
warning light by placing the metal contact points on the magnetic connector hub onto the screws in the LED warning
light (on the rear of warning light).
the screws in the LED warning light. Always ensure you place the poles in the right position. The (+) and (–) marks
on the magnetic connector hub and the LED warning light must always match.
12 V car power supply unit
Connect the USB charging cable to the magnetic connector hub and to the 12 V car power supply unit. Connect the 12
V car power supply unit to the corresponding socket.
230 V mains charger
Connect the USB charging cable into the magnetic connector hub and into the power supply unit for 230 V sockets.
Connect the 230 V power supply unit to the corresponding socket.
The battery takes about 2 to 3 hours to charge. A status LED on the magnetic connector hub indicates the charging status. The
status LED will light green whenever the battery is being charged. The status LED changes to red once the battery is fully
charged.
12V DC Charging adapter
The (+) and (–) marks are located on the magnetic connector hub and next to
Back
Magnetic connector
terminal polarity marks
Securing ring for hanging light
+ symbol
- Symbol
Charging points
Magnet
USB cable
STATUS LED
Is charging
*Green*
fully charged OR
*Red*
the Flare and Hun are
misaligned